Prewashing Panels Before Making Quilt
#1
Member
Thread Starter
Join Date: Jun 2017
Posts: 17
Prewashing Panels Before Making Quilt
Should panels be prewashed before making a quilt? I have seen patterns that say don't prewash the panel but nothing about prewashing the rest of the fabric. What is the best approach.
#2
I would say either prewash it all or don't prewash any of it. However, prewashing is a very personal thing. Many panels are very distorted when they come off the bolt. Wetting them can allow them to return to their original shape. Wetting them can also make cotton and especially flannelette distort as they dry. Yes, it is all very confusing.
I have had good luck with 'rinsing' my fabrics in as hot water as my hands will take, squeezing, not wringing, and then mostly drying in the dryer. That allows me to see any colour bleeds and provides the opportunity for shrinkage, as well as getting rid of a lot of the sizing that manufacturers use.
If the panel is significantly warped in shape, I will tape down two sides, dampen and gently (or aggressively on occasion) coax the other two sides into uniformity, continue to tape all around, wet fairly thoroughly, and let dry. It usually solves the problem.
I have had good luck with 'rinsing' my fabrics in as hot water as my hands will take, squeezing, not wringing, and then mostly drying in the dryer. That allows me to see any colour bleeds and provides the opportunity for shrinkage, as well as getting rid of a lot of the sizing that manufacturers use.
If the panel is significantly warped in shape, I will tape down two sides, dampen and gently (or aggressively on occasion) coax the other two sides into uniformity, continue to tape all around, wet fairly thoroughly, and let dry. It usually solves the problem.
#3
Power Poster
Join Date: Mar 2011
Location: Ontario, Canada
Posts: 41,464
It depends on the pattern. If you are makin a One Block Wonder pattern with the extra panel in the middle, then I would not wash any of the panels. In OBW you have to stack and match the panel patterns accurately. If it was for a different pattern, if the other fabric was washed, I would wash the panel also. After washing, you may need to block the panel square since they are seldomly on square.
#5
Super Member
Join Date: May 2013
Location: Ballwin, MO
Posts: 4,211
I've only made one panel quilt, and I did pre-wash the panel (I pre-wash all fabric). I used a pattern for the panel, and it did have the panel cut apart into separate pieces, with pieced blocks in between. It all worked out fine.
#6
I prewash yardage, FQs, and scraps, but I don't prewash precuts or panels. I routinely mix the prewashed and unwashed with no problems (so far). As you can see from the different answers, there is no one right way to do things.