Originally Posted by Horseladyquilter

My favorite method to do Sq. in a Sq is to:

Cut 2 squares the size I want my center square to be. Cut one out of the center square fabric and one out of the fabric you are using for your first row of triangles. Place the squares right sides together and pin. Sew around the outside of the square - 1/4" in. seam. I usually sew down one side and back up the opposite side, then do the other two opposite sides.

With the triangle fabric side up, and using a quilt marker and ruler, draw a diagonal line from corner to opposite corner. Then draw another diagonal connecting the remaining two corners. You will have an X in the center of your square.

Pull up a little on the center of the triangle fabric to separate the two squares, and snip on one of the lines. Cut through all the lines all the way to the corners of the triangle square, becareful not to cut through your center square fabric. Only cut the top layer.

Press open. Sometimes I cut the ears off and sometimes I don't.

Measure your new square and cut a square of your next fabric to match that. Repeat the instructions for the first square.

Then you may either repeat again, or start putting your straight pieces around the square.

I usually start with a 5 1/2" center square so I can do a small embroidery in it. With the first triangles pressed up, I have a 7" square and with the second row of triangles, a 9" square. You can, of course, use any size starting center you wish to. I find this easy and fast. Great for me because I'm not very good with triangles!

Originally Posted by charismah

I Actually use the square in a square ruler technique by Jodi barrows and it goes really quick and easy.....although spendy if you are trying to save money.I think teh ruler is around 20$ or something..but I think it is a good investment for perfect squares every time.

Originally Posted by quilter53

This is so easy. But when I open it up I have uneven sides. I was careful to draw my diagonal lines from corner to corner. Any suggestions. don't want to cut off the 1/4" seam allowance on the sides.

Originally Posted by quilter53

It is very easy but like I said my triangles aren't even.

Originally Posted by butterflywing

this has been bothering me. i tried it again and the triangles were fine. i starched the fabric and then laid out 6 layers. maybe you should begin with four. then i cut all the layers together, using my eight inch square. i made four stacks as a test. the starch made the layers stick to each other. since they were cut as one, they stayed put.

i was careful to cut straight, but i didn't worry about grain too much. i used a new blade and made sure it didn't wobble in the handle. i held the handle and blade straight up and down - very important!! i don't use those HF blades. i used a 45mm blade.

i finger pressed according to the directions. you could use the paper method. it won't matter. then i cut. i checked the triangles on one stack without mixing up the colors. i checked the triangles on the other stacks with mixing up the colors. they all worked.

did you do anything different?