QAYG No hand sewing!
#22
19. This shows the back of two blocks joined together. See how the two seam allowances nest nicely together ? You may want to press them gently into place with the point of your iron so they lay nice and flat.
#25
22. But first we have to make our backing strips. These need to be twice the width of the steam a seam, so 1 ½ inches wide. I don’t worry about length – I just cut a couple across the width of the fabric then trimmed them as I went – to lazy to do the maths ! But if you prefer to calculate how many you need in advance, go for it ! You need a backing strip for every joint between the blocks and then long strips to cover the joints in the rows later on. My strips are in the same fabric as my backing. It’s a fairly soft, thin unbleached cotton. Try and use something soft and fine or it will get really stiff.
#27
24. Then you want to press each side of the strip into the middle. I press the bottom side up first, then the top side down. It’s a bit fiddly at first but it goes pretty well. DON’T burn your fingers though !
#28
25. OK – now we take our steam a seam and lay it over the joint on the back of the blocks, so that it extends an equal amount each side of the stitching line. I then take my scissors (NOT the best fabric ones !) and trim it to length.
#30
27. Then press with the iron. The instructions say to use steam but I don’t – a dry iron is fine for a count of about 5 seconds. We’ll be stitching this down so we’re only looking for a temporary hold. Let it go completely cool before the next stage or it may come unstuck ! Once you’re underway, you can be sewing one piece together while the next piece is cooling. When it’s cool, trim off the excess backing strip, flush with the edge of the block.
Thread
Thread Starter
Forum
Replies
Last Post
nakotha
Pictures
21
02-12-2020 07:14 AM
craftybear
Links and Resources
5
09-18-2011 10:25 PM