Help! Trying to remove tiny stitches
04-12-2016, 03:59 PM
#11
Senior Member
Thread Starter
Join Date: Feb 2014
Location: Southern California
Posts: 341
I use the tiny rotary cutter to take out tiny stitches and big ones too. Once I can get to where the layers can be separated a bit and I can see the stitches holding the layers together, I pull up the top layer and start cutting with the rotary cutter little by little while continuing to pull up on the top layer and holding down the bottom one. Does that make any sense whatsoever? I have become a master at this technique .... which is a sad statement about my sewing/quilting. Good luck and take your time.
04-12-2016, 04:45 PM
#12
Super Member
Join Date: Mar 2013
Location: Southern Indiana
Posts: 3,111
I just had to do this myself - ugh! I had a little seam ripper and one of those seam rippers that are a blade tip (which scared me).. what worked the best for me was the tweezers. I never would have been able to finish without using the tweezers. They could grab a teeny piece of thread and hold on to it when I pulled threat out.
04-12-2016, 05:39 PM
#14
Super Member
Join Date: Jul 2014
Location: Illinois
Posts: 2,140
I had assumed it couldn't be separated, if it can, I found using my pointy embroidery scissors helps me get the threads clipped easier than a seam ripper. When I'm brave, I sometimes even just clip the threads on top. That way I don't have to try to get anything between the thread & top. I just put scissors straight upright (perpendicular to top) and clip carefully until I'm through both plies of the thread.
04-12-2016, 05:51 PM
#15
Super Member
Join Date: Mar 2011
Location: Central NJ
Posts: 5,571
This would be my suggestion as well. Painful but sometimes very necessary with those itty bitty stitches.
04-12-2016, 06:21 PM
#16
Super Member
Join Date: Jun 2010
Location: The Deep South near Cajun Country, USA
Posts: 5,410
When I have to rip something like that, I add some magnifying glasses and get the best light I can on the subject. Also, Hobby Lobby has a seam ripper that has one of the smallest points and that makes ripping somewhat easier. In the end, nothing is going to make ripping black on black a pleasure. It is just tough. Been there, done that!
04-13-2016, 04:11 AM
#18
Super Member
Join Date: Jun 2011
Location: Illinois
Posts: 9,018
Using the blade of the rotary cutter --- spreading the seam open -- isn't that scary...EB does it that way.
after you remove all those stitches...make a small scrap sandwich and check your machine stitching before starting again.....
after you remove all those stitches...make a small scrap sandwich and check your machine stitching before starting again.....
Thread
Thread Starter
Forum
Replies
Last Post
AFQSinc
Main
28
08-07-2012 03:31 AM
thequilteddove
Main
9
01-19-2010 07:18 AM
