candy_cane2011

I am new to quilting, only doing it for about a year, and I have come across a quilt that I would like to imitate but I am not sure how to do one thing. When making rows based on a diagonal, how do you fill the triangular gaps to make the quilt top square?

Thanks

Tiggersmom

Not as hard as you think.

There's special rulers for these.... I think Omnigrid makes one, Fons + porter, etc. Have fun!

candy_cane2011

Would you just make another disappearing 9 patch square and then use the ruler to cut it in half then sew it into the row?

Tartan

Bonnie Hunter has information on her site www.quiltville.blogspot.ca on figuring out setting triangles. She also has great free patterns under the free pattern tab.

quiltsRfun

Sew it into the row first, then sew the rows together. Trim the jagged edges after sewing the rows together making sure to leave the 1/4 inch seam allowance. If you cut the triangle in half you'll lose your 1/4 inch seam allowance along the outer edge.

katier825

I responded to your PM with details and tutorial links. I didn't use a special ruler, I just used a large square ruler.

katier825

I cut the blocks in half for the triangle units when I made this. I just trimmed the edges of the quilt down before adding the borders. It's so busy, I didn't feel it took away from the look by doing so.

[ATTACH=CONFIG]528187[/ATTACH]

dunster

One decision you need to make is whether you want the setting triangles and corner triangles to be a single fabric, or whether you want them to continue the pattern in the rest of the quilt. It's a lot easier to make them out of a single fabric, and I think it's usually more interesting than continuing the block pattern, but it's a design decision. The link below is useful if you're using a single fabric. http://www.generations-quilt-pattern...triangles.html Using the methods shown for corner and setting triangles assures that the edges of the quilt will not have bias edges.

If you want to continue the blocks patterns right to the edge, then the method quiltsRfun suggests is one way to go, possibly the easiest and most intuitive way, but of course you will wind up with almost half of a bunch of blocks that are cut away, and fairly difficult to use in another quilt, plus you will have the dreaded bias edges on your quilt.

In any case, you do need to add the triangles or blocks as you sew each diagonal strip together. If you don't, you will wind up with gaps that require set-in seams.

ManiacQuilter2

You fill the gaps with what are called Setting Triangles. I made this D9P because of the limited blocks I had. There are rulers made just for cutting the correct size. I always make them bigger because it is easier to trim them than to add fabric if you are short.

Geri B

Don't just take a square and cut it once diagonally......you will have bias edges all the way around....could spell disaster for a relatively new quilter. Check out the sites/ways to do setting triangles to do it correctly - the initial block is cut diagonally, but twice on a much larger square, thus giving you a nice straight of grain edge...

Go to your local library and get a few quilt books.......there is usually how to pages in these books tag will also help you....