Pfaff 16.0 PowerQuilter Speed Control
06-24-2016, 01:58 AM
#1
Member
Thread Starter
Join Date: Jun 2016
Posts: 1
Pfaff 16.0 PowerQuilter Speed Control
Hello,
I would like to change the foot pedal control that is supplied with the machine for a hand held such as that made by The Grace Company, however, the connection to the machine is a vga type.
Does anyone have experience of this conversion?
I would like to change the foot pedal control that is supplied with the machine for a hand held such as that made by The Grace Company, however, the connection to the machine is a vga type.
Does anyone have experience of this conversion?
12-01-2021, 08:12 AM
#3
Member
Join Date: Aug 2015
Location: Cabot, AR
Posts: 29
this is a long shot because this is an old post but I am seeking to do the same thing with my power quilter did you figure it out?
10-17-2023, 12:00 PM
#4
Member
Join Date: Oct 2023
Posts: 1
Pfaff 16.0 powerquilter foot control issue
My power quilter error message says no foot pedal. So because it does not recognize it I can’t do anything. Has someone else had this problem? Is it just the foot pedal ( which was new last July) or the pin connector for the foot on the machine?
when I turn the machine on it runs on its on with the error message and quickly gets up to high speed so I have to shut it off.
many ideas or suggest would be helpful.
when I turn the machine on it runs on its on with the error message and quickly gets up to high speed so I have to shut it off.
many ideas or suggest would be helpful.
Thread
Thread Starter
Forum
Replies
Last Post
