glue basting questions
#1
glue basting questions
I will be glue basting a quilt for the first time today and have a couple questions for the experts! I found a very thin poly batting (quilters dream I think) that was recommended to help achieve a flat finish. The liquid washable school glue works ok with poly, right? If I don't iron the glue and just let it air dry, how long does it take to set up? I also will be drawing my fmq design onto the top with the Frixxion pen, but not sure if I should be putting the design on before basting? or after? Will the glue affect the way the ink works? Thanks in advance for your help!
#3
I have glue basted with poly batting with no problems. If you were ironing your glue dry I'd say to use the Frixion pen after but since you're letting it air dry I'm not sure if it would matter when you traced your design on. It may be easier without the batting underneath. Can't help with the drying question. I've always ironed mine dry.
#4
I always iron dry mine. If you decide not to, be sure to press/smoothe your quilt well to make the glue adhere to the fabric. let it dry untill the glue is hard. As for the pen, not a clue, since I have never used it. Good luck.
#7
I'm trying the glue because I can buy a big bottle of glue for a dollar....spray basting is messy (overspray), expensive, and I can put the glue on the batting, allowing me to see the backing/top and smooth away any wrinkles before the glue dries. I've already done the top and am thrilled with how easily it works, the backing is half done and is 100% smooth! It does take a bit longer, but well worth the effort. For those of you who iron the glue dry, are you spreading your quilt on the floor to iron? what are you putting underneath to protect the surface? I have currently spread my quilt out on the pool table and doing about 1/3 at a time, but no ironing there....hubby would disown me
Thread
Thread Starter
Forum
Replies
Last Post
IBQUILTIN
General Chit-Chat (non-quilting talk)
10
07-10-2015 09:59 AM