EQ5 users, I need help please
07-16-2009, 06:51 PM
#2
Senior Member
Join Date: Nov 2008
Location: Pacific NW USA
Posts: 883
After drawing your block, place the block into the Blocks scrapbook.
Then make sure you are in the Quilt Layout tab.
Hold down the Control Key while and Clicking on the Set Block button.
That should set the same design into every block.
Then make sure you are in the Quilt Layout tab.
Hold down the Control Key while and Clicking on the Set Block button.
That should set the same design into every block.
07-17-2009, 04:58 AM
#3
Power Poster
Thread Starter
Join Date: May 2008
Location: FL
Posts: 16,574
Should I be on layer 2? I tried that and it didn't work :-(
Another question, how do I find the layout options to lift the restriction? I couldn't find it in the manual.
I've been using this software for a year and never could figure this problem out :(
Thanks!
Another question, how do I find the layout options to lift the restriction? I couldn't find it in the manual.
I've been using this software for a year and never could figure this problem out :(
Thanks!
Thread
Thread Starter
Forum
Replies
Last Post
mamatobugboo
Main
4
06-29-2009 06:32 PM
