Singer 503 in cabinet - help with foot pedal!
#1
If any of you have a Singer 503 in a cabinet, I could use your help! I cannot figure out how to attach the knee lever to the cabinet. It looks like it may screw onto the hardware inside the cabinet but a screw was not included with the machine (I bought it used) and I don't see where it would screw in anyway. Any help would be appreciated!
#3
Until you find out how to attach the lever, (which may be broken beyond repair) you can just slide the foot control out of the bracket and use it on the floor as a foot control. It slides either straight up or straight down to get it out of the bracket.
Replacing the entire bracket and knee lever is easy and relatively cheap, but until then, you don't have to be without a machine. :)
Replacing the entire bracket and knee lever is easy and relatively cheap, but until then, you don't have to be without a machine. :)
#4
Banned
Join Date: Oct 2009
Location: Bikini Bottom
Posts: 5,652
Originally Posted by KarenS
If any of you have a Singer 503 in a cabinet, I could use your help! I cannot figure out how to attach the knee lever to the cabinet. It looks like it may screw onto the hardware inside the cabinet but a screw was not included with the machine (I bought it used) and I don't see where it would screw in anyway. Any help would be appreciated!
I have a complete setup for the knee lever sitting in my studio if you need parts of the whole thing.
Billy
#6
Sorry, I sent that last one by mistake. My problem is trying to attach the KNEE LEVER to the hardware inside the cabinet. I may be missing a part, I don't know. Do you have a photo of what it is supposed to look like?
#8
Originally Posted by KarenS
Sorry, I sent that last one by mistake. My problem is trying to attach the KNEE LEVER to the hardware inside the cabinet. I may be missing a part, I don't know. Do you have a photo of what it is supposed to look like?
#9
Here are a couple pictures, one of the hardware inside the cabinet, and one of the knee lever. I hope someone can let me know if I am missing some parts, or how to attach the lever. Thanks for any help you can give me.
#10
On my 503, the control slides into the bracket on the top picture. Hope this makes sense.. If you need me to, I can take a picture if it. I just had surgery on my right hand so I am down to one hand...
Thread
Thread Starter
Forum
Replies
Last Post
joobee
For Vintage & Antique Machine Enthusiasts
9
04-07-2014 06:04 AM
Treasureit
Links and Resources
56
07-21-2013 07:33 AM
Brenda Sue
For Vintage & Antique Machine Enthusiasts
10
06-06-2010 09:23 AM