Where to find a bobbin winder replacement part on Singer 15-91
06-02-2013, 04:33 PM
#1
Member
Thread Starter
Join Date: Nov 2012
Location: Ohio
Posts: 82
Where to find a bobbin winder replacement part on Singer 15-91
Hello...On my Singer 15-91 I slide my bobbin on the winder (fits and stays on there great) then I make sure the little pin is engaged in the side of the bobbin and push down my winder to lock it in, but when I start to wind, my little bobbin pin has a hard time staying in the side of my bobbin and it keeps slipping out. I have adjusted the bobbin wheel and tried a metal and plastic bobbin in the right size. Do these little pins get worn down? Can they be replaced, if so does an online store carry them?
Thanks so much!!!
Thanks so much!!!
Last edited by BirdyFeathers; 06-02-2013 at 04:43 PM.
06-02-2013, 05:36 PM
#2
Super Member
Join Date: Dec 2011
Location: Northern CA near Sacramento
Posts: 1,107
Birdyfeathers,
When the bobbin winder is presser down against the hand wheel there is a finger that drops down between the sides of the bobbin. Press this finger to the right side towards the bobbin winder. Light tapping with a rubber mallet is sometimes necessary. This is a normal adjustment as the finger frequently gets bent towards the left and wil no longer keep the bobbin on the pin.
Cathy
When the bobbin winder is presser down against the hand wheel there is a finger that drops down between the sides of the bobbin. Press this finger to the right side towards the bobbin winder. Light tapping with a rubber mallet is sometimes necessary. This is a normal adjustment as the finger frequently gets bent towards the left and wil no longer keep the bobbin on the pin.
Cathy
Hello...On my Singer 15-91 I slide my bobbin on the winder (fits and stays on there great) then I make sure the little pin is engaged in the side of the bobbin and push down my winder to lock it in, but when I start to wind, my little bobbin pin has a hard time staying in the side of my bobbin and it keeps slipping out. I have adjusted the bobbin wheel and tried a metal and plastic bobbin in the right size. Do these little pins get worn down? Can they be replaced, if so does an online store carry them?
Thanks so much!!!
Thanks so much!!!
06-02-2013, 07:00 PM
#3
Member
Thread Starter
Join Date: Nov 2012
Location: Ohio
Posts: 82
Hi Cathy,
Thank you very much!! I did just as you said and it worked perfectly!!
Thank you very much!! I did just as you said and it worked perfectly!!
Birdyfeathers,
When the bobbin winder is presser down against the hand wheel there is a finger that drops down between the sides of the bobbin. Press this finger to the right side towards the bobbin winder. Light tapping with a rubber mallet is sometimes necessary. This is a normal adjustment as the finger frequently gets bent towards the left and wil no longer keep the bobbin on the pin.
Cathy
When the bobbin winder is presser down against the hand wheel there is a finger that drops down between the sides of the bobbin. Press this finger to the right side towards the bobbin winder. Light tapping with a rubber mallet is sometimes necessary. This is a normal adjustment as the finger frequently gets bent towards the left and wil no longer keep the bobbin on the pin.
Cathy
Thread
Thread Starter
Forum
Replies
Last Post
sews
For Vintage & Antique Machine Enthusiasts
25
05-19-2015 06:04 AM
craftybear
Links and Resources
10
06-10-2011 03:13 AM
craftybear
Links and Resources
2
02-19-2011 07:24 AM
