natetheaverage

Ok I have run into a bit of a snag with my automatic cutter.

Somehow the bobbing got wound up around the automatic cutter to the point where I had to disassemble it. Normally I am very good at taking note of how things go together while taking them apart but I lost the screw and retrieved it from inside the machine. In fretting over getting the screw out I forgot the order that the parts went back together, so some help here would be most appreciated.

When looking down at the machine there is a screw to the top left of the bobbin that holds a guild for the automatic cutter head the 3pieces are held in line with a "pin" for lack of a better word.

Now the problem is the cutter will work just fine with out these 3pieces and the throat plate off (done to make sure there wasn't a timing issue)

Basically what i am looking at is 3 pieces and their profiles look as follows

A) ___|----

B) ---------

C) ______|

Now I know (A) goes up top however I can't remember if (B) get sandwiched between them and slid in between the cutter itself or what.

Any help would be greatly appreciated