Originally Posted by
J Miller
Ron,
Could you post a picture showing the binding being installed?
Joe
Joe, 1st photo is a setup of 1 inch binding on a scrap of lawn chair sling material. The second is a photo of the stitch. Notice I started the stitching with the needle centered. Then switched to needle left making a better balance of margins. If I was seriously setting it up, I'd probably adjust the attachment to use needle center stitching. This was a quick setup for demonstration. If I was joining materials the lower material would be entering stitch area from below the attachment's plate.
[ATTACH=CONFIG]436770[/ATTACH][ATTACH=CONFIG]436771[/ATTACH]