You can do it, it'll just require a lot more steady hand. If it were me, I would gather a few pieces (read the directions) and peel the paper off and lay them on that side, about 1/2" close to each other. The tricky part is ironing and not getting the fusible stuck on anything. You can press firmly and the pieces will stay on the Heat and Bond and you can cut them out carefully and then use an applique pressing sheet over them when you go to iron them onto your fabric. Be careful because you'll probably get bits that will stick to your pressing sheet. Remove pressing sheet after it's cooled off. That is what I have done before when I was in your predicament. Don't beat yourself up over this. We all learn new things every day! Good lucki!