The designer of the free pattern from quiltview offers both rotary or die cutting instructions. It is a rather briefly written pattern, but it's free, so...
I do have the SaS pattern from when Accuquilt offerd it as a free download (2011). One of the benefits of a mmbership is that pattens you buy (including those that you "buy" when they are offered free) are linked to your account, so you can open them at any time, although the free ones do have a limited number of downloads.
The Accuquilt pattern uses the same dies. If you look in the blue box on page 60 from the free pattern linked above, you will see a note that the "B" unit is constructed of 2 pieces that were die cut with the Go!:
• B – For each B triangle cut 2 D triangles then join on the short sides (fig. 1)
• C – GO! Half Square – 3" Finished Triangle (55009)
• D – GO! Half Square – 1½" Finished Triangle (55319)
Perhaps when the pattern was written, the sizes that would seem to be more efficient had not yet been made?
There is an Accuquilt yahoo group; I am going to post a question for folks who might have used the pattern to see which method they used.
Last edited by peaceandjoy; 07-08-2014 at 06:10 PM.