Block size? Check my math please?
#11
Originally Posted by Lisa_wanna_b_quilter
http://www.karencombs.com/setting_triang.htm
This chart will help with the setting triangles.
As for the 9 patch blocks, each square needs to be 4.5 inches. With your seam allowance you should end up with a 12.5 unfinished block or a 12 inch finished block.
This chart will help with the setting triangles.
As for the 9 patch blocks, each square needs to be 4.5 inches. With your seam allowance you should end up with a 12.5 unfinished block or a 12 inch finished block.
#12
Originally Posted by Millstream Mom
I want to make a 9 patch block. If my finished block will be 12" then I should make my blocks all 4.5"? I will have 1/4" seams which would end up with 3 x 4" per row?
OK... now I want to set the blocks on point so they will be set in as diamonds instead of running with the seams horizontally. I want to set 6 diamonds (which are my 9 patch blocks) running down a column. My question is about the half-square I will need to put between each 'diamond', as well as the small triangle at the top of each strip
My block is 12.5" (12"finished size plus 1/4" seam allowance on each side. Do I cut a block 12.5" then cut into 2 large triangles, to make the pieces I need to set in? For some reason I'm thinking that will make it too short on one side?? And what about that little triangle I need to cut for the top corners? UGH!! Right now I'm suffering from "Paralysis by Analysis"
:roll: Please.... I need your input!
OK... now I want to set the blocks on point so they will be set in as diamonds instead of running with the seams horizontally. I want to set 6 diamonds (which are my 9 patch blocks) running down a column. My question is about the half-square I will need to put between each 'diamond', as well as the small triangle at the top of each strip
My block is 12.5" (12"finished size plus 1/4" seam allowance on each side. Do I cut a block 12.5" then cut into 2 large triangles, to make the pieces I need to set in? For some reason I'm thinking that will make it too short on one side?? And what about that little triangle I need to cut for the top corners? UGH!! Right now I'm suffering from "Paralysis by Analysis"
:roll: Please.... I need your input!
http://quiltville.com/onpointmath.shtml
Scroll down, there are the measurements by 1/2 ".
Thread
Thread Starter
Forum
Replies
Last Post
judylg
Main
4
03-26-2013 07:09 AM