Cleaning a sewing machine
#23
My first lesson with any new pupil is how to clean and care for their machine. The hardest thing I have found is on new machines is getting the screws out of the sewing plate as they have been over tightened by machine. I always teach them how to take off the bottom of their machine and de-fuzz as they also need to know how to remove it to check when a needle breaks, that there is no bits in the bobbin holder or gears, don't ask me how I know! They are also taught how to polish their machines with a silicone colourless polish as this helps so much with the smoothness of fabric movement, and of course which oil to use and where to use it. They are all now proficient on looking after their machines and have never had to go to a repair man, so I must be doing something right, heehee.
#24
Junior Member
Join Date: Jul 2012
Location: SW WA State
Posts: 140
Oh dear! I fear I have been abusing my poor Elna! I have only cleaned out the bobbin area and underneath the plate around it! I guess I now have a project to complete today. What kind of oil would you recommend for the machines? Is this something I can pick up at Joann's or something like it? The only oil in the house is WD-40 and my husbands gun oil.
#25
Oh dear! I fear I have been abusing my poor Elna! I have only cleaned out the bobbin area and underneath the plate around it! I guess I now have a project to complete today. What kind of oil would you recommend for the machines? Is this something I can pick up at Joann's or something like it? The only oil in the house is WD-40 and my husbands gun oil.
#26
Junior Member
Join Date: Oct 2007
Location: Macon, Ga
Posts: 272
I put machine oil on a Q-tip and clean around the feed dogs, where the bobbin goes in, and to the left in the inside of the machine. Do NOT run the Q-tip to the right because the mechine's "works" are there. Whenever I use black thread or fabric, I clean the machine well because the black has carbin in it and will eventually harm the machine.
#27
Senior Member
Join Date: Jul 2012
Posts: 319
#28
Senior Member
Join Date: Jul 2009
Location: Columbus, Ohio
Posts: 375
I have an Elna 7300 and it is computerized. Do you think I can take it apart to clean?
ALWAYS, ALWAYS use a Sewing machine oil, the one that I have is Singer but you normally get a tube when you get a machine. I have an Elna 7200 and this topic reminded me that I hadn't cleaned out the bottom of mine for a while so I did it just now and this is what I found, I also have 3 very clogged up dirty brushes full of fuzzies as well!
#30
The best thing I have found to clean my machines is pipe cleaners. I went to a "dollar store" and bought a bag of long one that are sold for kids crafting. They pick every bit of lint and don't let go. I've been told on a couple of occasions by sewing machine mechanics that I have a very clean machine.
Thread
Thread Starter
Forum
Replies
Last Post
dakotamaid
For Vintage & Antique Machine Enthusiasts
31
12-06-2011 01:25 PM
Tallbald
For Vintage & Antique Machine Enthusiasts
5
11-17-2011 04:09 AM