Crooked Stitches!
#41
Senior Member
Join Date: Jan 2011
Location: Richmond, VA
Posts: 601
Stitch width not at zero can do that -- but I don't think there'd be a setting that close to zero -- I had a similar problem with a mechanical Pfaff and it turned out that the machine was not completely re-setting when I went from zig zag back to straight stitch.
#42
Senior Member
Join Date: Jan 2011
Location: Richmond, VA
Posts: 601
Stitch width (not stitch length) not at zero can do that -- but I don't think there'd be a setting that close to zero -- I had a similar problem with a mechanical Pfaff and it turned out that the machine was not completely re-setting when I went from zig zag back to straight stitch.
#44
Power Poster
Join Date: May 2008
Location: MN
Posts: 24,654
#45
The main page for the manual is at https://support.brother.com/g/b/manu...3=626&type2=69 and the manual link is https://download.brother.com/welcome...om_b03enes.pdf
As a side note, the OP hasn't been active since her last post on this thread.
Peckish, thank you for the current link for this informative bit of information
Janey - Neat people never make the exciting discoveries I do.
Not affiliated with off-site link(s)
Last edited by OurWorkbench; 09-11-2020 at 07:00 AM.
Thread
Thread Starter
Forum
Replies
Last Post