Geri B

...wish there was a paper factory near here.....there used to be a newspaper printing place not too far away, but they closed.........

The trouble with online ordering sometimes S&H takes away " the great price"

pegquilter8

Find a Dr.'s office that will give you a roll of paper used on the tables. It is HUGE and should last quite awhile. Mine I have had for over two years and it never seems to get smaller. I use it for any piecing project that requires smaller than 1 1/2" cuts.

Old Spice

I buy padded paper at $Store in the school supply section. 9 1/2 x 12 that works great. Also use it for stabilizer when doing applique to keep design from puckering.

maviskw

You should try this freezer paper way. A friend made 20 blocks with the same piece of paper. And no paper ripping.

wendiq

I prefer the regular foundation paper, but have used my 20wt. copy paper and it works pretty good. Just use a small stitch and I prefer to use a size 14 needle......just take a little care when pulling the paper off....in other words, don't stress the fabric......

GheckoAZ

This the paper I use also. The only problem I have is that my printer only lets me use one sheet at a time.

Joanie2

For my last PP project I used the Scribble Pads at the $ store. Only issue is that I had to cut the paper down to fit into my printer. It does run through my printer well with no issues. A friend offered me a tip and it works well with me---before sewing any fabric to your paper fold on all the lines using your fingernail to make a nice crisp crease. She will usually do this step while she's watching TV or sitting in a meeting. This helps to line up your fabric and makes tearing off the paper so much easier. I've tried it with my last project of 224 blocks and it worked well.

cpfrog

I have used a pad of 8.5 x 11 inch tracing paper at office supplies stores or Pat Catan's or maybe Michaels?;

You might also be able to get a roll of "canary paper" (pale yellow) at an art supply store that might be reasonably priced (haven't bought that in years!). That you can cut to size, but might have trouble in a printer.

Otherwise reg. copy paper (cheaper the better) with shortened stitch lengths.

Good luck.

MargeD

I've always used regular copy paper and it works. Although Mdegenhart has a good idea of buying 8 1/2 x 11 newsprint, which would go through the printer and would tear away easier; however, using a small stitch, then a technique I learned in a class with Carol Doak, you pull on 2 corners of the block, then the other 2, which helps release the paper.

ghostrider

The reason I don't reduce my stitch length when paper piecing is because it makes removing the stitches in case of 'misplacement' completely impossible plus dinky stitches can pull the fabric too tight resulting in a puckered block.

In my experience, folding on the stitch line after the block is done or brushing the stitches with a damp paint brush are all that's needed to remove most types of paper effortlessly even with normal piecing stitch lengths.