Four patch technique question
#1
Four patch technique question
Let me explain how I'm making these and then I'll ask my question.
First, I starched the fabrics prior to cutting them into 1 7/8" wide strips along WOF.
I'm sewing a strip of purple to a strip of white using a 1/4" seam.
Then I align the sewn edge along a 4' metal ruler to make sure it is straight, then press to set the seam.
I let the pieces cool before I move them.
Here's my question:
Is it better to cut these long strips into 1 7/8" wide pieces now, before they are pressed open, using the sewn edge as a straight guide......
or.....
Is it better to finger press and then open the long strips, press flat, and then cut into 1 7/8" pieces?
I'm cutting them a little larger so I can trim them to 3" squares when finished. I need a total of 288 four patch units, and I'm looking for the most accurate method. Is there any real difference between the above mentioned methods?
Thanks for any replies.....
Barb
First, I starched the fabrics prior to cutting them into 1 7/8" wide strips along WOF.
I'm sewing a strip of purple to a strip of white using a 1/4" seam.
Then I align the sewn edge along a 4' metal ruler to make sure it is straight, then press to set the seam.
I let the pieces cool before I move them.
Here's my question:
Is it better to cut these long strips into 1 7/8" wide pieces now, before they are pressed open, using the sewn edge as a straight guide......
or.....
Is it better to finger press and then open the long strips, press flat, and then cut into 1 7/8" pieces?
I'm cutting them a little larger so I can trim them to 3" squares when finished. I need a total of 288 four patch units, and I'm looking for the most accurate method. Is there any real difference between the above mentioned methods?
Thanks for any replies.....
Barb
#3
Lay your pressed open strips for the two sides on top of each other, right sides together, align and then cut. Then you are ready to go with the next stage of sewing, your pieces already matched up.
#5
Super Member
Join Date: Dec 2012
Posts: 1,857
I am puzzled by the 'press them open'. I would be pressing the seams to the purple side. First, because it would be less visible and second, it would allow for nesting. But, I wouldn't cut until after pressing to aid in less chance of distortion (easier to move and handle a long piece rather than fiddly little pieces). I agree with cutting them a bit bigger. I learned long ago that the tiny bit of waste is so much better than ending up with a couple square too small!
#6
Super Member
Join Date: Jan 2011
Location: northeast NE
Posts: 1,072
After watching many of the 'renowned' quilters in tutorials, it appears they finger press the seams open before taking the iron to press them open. I've been doing that and find it much less tedious that way. Good luck.
#7
Super Member
Join Date: May 2012
Location: Central Wisconsin
Posts: 4,391
I agree with this post. When I had a pile to press open, I finger pressed them while sitting in my easy chair. I set them aside in a stack. When the stack threatened to fall over, I made a new stack. When I got to the ironing board, they were easy to iron quickly with no burnt fingers.
#9
Super Member
Join Date: Aug 2013
Location: Florida
Posts: 5,967
I like layering two purple/white strips on top of each other. (Pressed to the purple) One purple side down then one purple side up, then cutting each one to the correct width. I measure the sewn seam not the edge. I want the cut to be perpendicular to the seam.
Thread
Thread Starter
Forum
Replies
Last Post
craftybear
Links and Resources
2
05-13-2011 08:50 AM