Help With My Baby Lock Tiara
#12
Member
Join Date: Aug 2014
Posts: 17
This happened to me yesterday while sewing along fine... I was using the thread holder for cones when I noticed thread looked very taut and when I touched it it was ! Too tight !...and sure enough when I checked the back of the item I was sewing ...Big LOOPS !...The thread had been restricted by the cord from my lamp that was laying on top of it. I thought that I had put the cord out of the way but apparently not.
#13
Junior Member
Join Date: Jan 2013
Location: Brooksville, FL
Posts: 207
It happened to me today on my tiara. I didn't have it in the tension section. Flossed it and it worked. I find I have to check it after I wind a bobbin. I also have a problem with the bobbin making loops on the outside of the bobbin. Hard to describe. But I have to keep stopping and take the bobbin out then put it back in. Not sure if it's not wound right or what the problem is.
#14
It happened to me today on my tiara. I didn't have it in the tension section. Flossed it and it worked. I find I have to check it after I wind a bobbin. I also have a problem with the bobbin making loops on the outside of the bobbin. Hard to describe. But I have to keep stopping and take the bobbin out then put it back in. Not sure if it's not wound right or what the problem is.
#15
Senior Member
Join Date: Jan 2011
Posts: 659
#18
Super Member
Join Date: Jan 2011
Location: Chagrin Falls, Ohio
Posts: 1,274
Fabric could be wound too tightly on the frame. Lots of videos on YouTube for the Handiquilter. I think the Tiara is just like the Handiquilter Avante (and made by same company).
Thread
Thread Starter
Forum
Replies
Last Post
AlienQuilter
Main
34
06-20-2013 06:50 AM