After all your nice comments I ruined it.
#3
Super Member
Join Date: Jul 2010
Location: A Hop from Heaven, a Skip from Sanity and a Jump from the Good Life....
Posts: 6,665
Originally Posted by CindyinNY
Yes, I did!!!!! I cut one side of my table off and it's crooked. :cry: :cry:
#6
Put the cut piece back on. Drill a couple of holes in the cut end and match the holes and drill the same amount of holes in the table cut end. Hammer a short piece of dowel rod covered in good wood glue, a little bigger then the hole into the table end holes then tap the cut end on the dowels. Now you are right back where you started and can cut it even.
Thread
Thread Starter
Forum
Replies
Last Post
ND-Mom
Pictures
33
08-14-2018 06:55 PM
elainer
Pictures
5
01-28-2011 11:47 AM