Ironing board fiasco
#21
Super Member
Join Date: Jul 2010
Location: Glenmoore, PA
Posts: 7,941
Originally Posted by mjsylvstr
Originally Posted by G'ma Kay
So... my FIL has a scrap piece of plywood, 22 X 48 just perfect for my sewing table pressing board. I'm so excited! I use an old mattress pad for the padding, an old sheet for the cover, my DH's staple gun to put it all together and turn it over and .... Wallah! The staples are too long because it's 1/4 inch plywood. It pokes through the cover on the top. I pulled them all out and will have to think on this one a while.
#22
When I made my board larger with plywood, I was told by a quilt shop owner to drill some holes where the main ironing will be done. It seems they made some for the shop and wondered why their steam irons were always burning out. Said the steam had to get out or it does something to irons to burn them out. When I look most ironing boards do have holes in the top (before you put the padding on) Not sure if this is true, but mine works OK with the holes drilled. I put layer of insulbrite then layer of cotton batting then top fabric. Has anyone had the problem of burned out irons?
#24
Originally Posted by grann of 6
Originally Posted by mjsylvstr
Originally Posted by G'ma Kay
So... my FIL has a scrap piece of plywood, 22 X 48 just perfect for my sewing table pressing board. I'm so excited! I use an old mattress pad for the padding, an old sheet for the cover, my DH's staple gun to put it all together and turn it over and .... Wallah! The staples are too long because it's 1/4 inch plywood. It pokes through the cover on the top. I pulled them all out and will have to think on this one a while.
#25
Originally Posted by quilt3311
When I made my board larger with plywood, I was told by a quilt shop owner to drill some holes where the main ironing will be done. It seems they made some for the shop and wondered why their steam irons were always burning out. Said the steam had to get out or it does something to irons to burn them out. When I look most ironing boards do have holes in the top (before you put the padding on) Not sure if this is true, but mine works OK with the holes drilled. I put layer of insulbrite then layer of cotton batting then top fabric. Has anyone had the problem of burned out irons?
but if we make another, I will definitely put the holes to be on the safe side.
#26
This would require you taking it apart, but I put a frame of 1" X 2" boards all the way around the outer edge of my plywood , on the underside. This gives thickness for your staples to not poke thru as well as a lot of stability for the whole board.
#29
Why not sew a 1" hem all around your sheet, and run
elastic or strips of cotton through that to tie tightly.
Could do same with your padding, so all would be easily
removed for laundering. In other words the padding is
made same as retail ones.
elastic or strips of cotton through that to tie tightly.
Could do same with your padding, so all would be easily
removed for laundering. In other words the padding is
made same as retail ones.
#30
Sharon Schamber has directions on her site for making a firm ironing surface from plywood, batting and canvas. I made 2, one goes on top of my ironing board and a smaller version goes next to the sewing machine.
Thread
Thread Starter
Forum
Replies
Last Post
craftybear
Links and Resources
15
04-07-2013 02:59 AM
craftybear
Links and Resources
7
06-02-2011 04:39 PM
craftybear
Links and Resources
14
11-28-2010 09:07 AM