Joining binding strips
#21
#22
Junior Member
Join Date: Jul 2019
Posts: 165
Depends on style of final joining you use. We use 2 1/4” wide binding. Then we figure the circumference of quilt plus 20l”. This gives us plenty for corners and our join and extra to move seams around so none end up on corners.
#23
Gee Guys where were you two days ago when I was in a huge hurry to bind a quilt and thought I had calculated rightishly einough. When I put it on, I was short by 4 inches!!!! Dang!! I know it just took a bit more time but--Dang!!
#24
Super Member
Join Date: Jan 2012
Posts: 4,783
#25
Power Poster
Join Date: May 2008
Location: MN
Posts: 24,654
I am in the "I would rather have a lot left over, than be 1/2 inch short" group.
Because I usually use bias binding, and I cut the strips as long as I can from the fabric I have available, I usually start with measuring/calculating the perimeter of the quilt.
That continuous method where a piece is sewn into a tube and then cut - it seems to me that there would be a lot of seams in the binding - and I try to have as few as possible.
I usually cut the strips about 2-7/8 to 3 inches wide. Because the ends of the strips are usually diagonal to the main part of the strips, I measure the "available" lengths for "when I think I have enough".
I also usually have two big triangles left - which do not fold up tidily. But "my circus, my monkey".
I also like to have the flexibility to adjust where a seam falls - I do not like to fight with the extra bulk at a corner.
I also like to have a bit extra for the final join.
Turns out I don't actually "calculate" - I think I do more of a "add up the lengths as I go" until I have "enough" - which is usually a lot more than the minimum needed.
I can eke out, squeak out, as well as almost anyone - but if I don't need to, I tend to be "extravagant".
Because I usually use bias binding, and I cut the strips as long as I can from the fabric I have available, I usually start with measuring/calculating the perimeter of the quilt.
That continuous method where a piece is sewn into a tube and then cut - it seems to me that there would be a lot of seams in the binding - and I try to have as few as possible.
I usually cut the strips about 2-7/8 to 3 inches wide. Because the ends of the strips are usually diagonal to the main part of the strips, I measure the "available" lengths for "when I think I have enough".
I also usually have two big triangles left - which do not fold up tidily. But "my circus, my monkey".
I also like to have the flexibility to adjust where a seam falls - I do not like to fight with the extra bulk at a corner.
I also like to have a bit extra for the final join.
Turns out I don't actually "calculate" - I think I do more of a "add up the lengths as I go" until I have "enough" - which is usually a lot more than the minimum needed.
I can eke out, squeak out, as well as almost anyone - but if I don't need to, I tend to be "extravagant".
Last edited by bearisgray; 09-13-2019 at 06:06 AM.
#26
Super Member
Join Date: Aug 2010
Location: Kansas City, Missouri
Posts: 1,040
I do the same thing. Better to have too much than too little
Thread
Thread Starter
Forum
Replies
Last Post
craftybear
Links and Resources
3
12-25-2010 09:49 PM