pinkberrykay

[ATTACH=CONFIG]304175[/ATTACH] After I was done, I notices these loose stitches on the back. What happened???

Thanks for your help.

Peckish

Your tension was off. If it's on the back, that means you should check and re-thread your top thread. Usually when I see this, it means my thread caught on something, like the carry handle, and the thread path was impeded.

crafty pat

When my machine does that it is usually a tension problem or lent or thread caught under my bobbin case. I hope this helps you.

pinkberrykay

Thanks ladies it does, Ill rethread.

moreland

I have found on my machine I need to pull the thread completely out and start rethreading from the spool down--I don't know why it makes any difference but it seems to, especially on my Bernina.

lab fairy

I am going to assume your machine was sewing just fine before the loose stitching. First rule when something like this happens is to completely unthread the machine (bobbin too) clean the lint out and rethread. Followed by: check tension and change the needle. You might also need to look at the feed dogs and see if there is a bunch of lint packed up in that area (especially under the needle plate).

Tartan

Well the good news is it should be easy to slip your seam ripper under the stitches to take it out. Re-thread as others have said and sometimes I have found that if the fabric is really dense like batik it can cause problems. I put in a new needle to pierce the fabric better. The thread can also give you trouble if a very sticky fusible is used. Good luck.

WilliP

I would also use a tearaway or washaway stablizer under the applique project. New threading, new sharp needle (not a universal), and the right stablizer save me a lot of fix it time in the long run. I am still learning to use my machines for applique and do enough stuff that I have to rip out so I try to fix the basics ahead of time. I'm finding the metafil needles and topstitch needles work best depending on my thread. Also have to check for nicks and burs on the throat plate of one machine on occaision --timing got off once and the resulting needle nick caused problems until I emeried it out.

noahscats7

If you had your feed dogs lowered....put them back up. Lowering them changes the upper tension. glenda

QuiltnNan

also, make sure that you had your presser foot down... although it doesn't really look messy enough for that to have been the issue.