Something I noticed ...Bobbin
#1
Something I noticed ...Bobbin
This an M Class bobbin, but not sure it makes a difference.
I'm having trouble with tension lately. I can't seem to get it to stay equal. Usually I've got front thread on the back regardless of how I adjust the top tension, even when the bobbin tension says it is correct.
I've noticed something on my bobbin. When I load my bobbin into the casing, I always make sure the thread is around the little hook. First picture. [ATTACH=CONFIG]603148[/ATTACH] And that is what I tension my bobbin for, using Jamie Wallen's technique.
If I take my bobbin out halfway for whatever reason, I notice the thread is no longer around the hook but has slipped down as in the second picture, and that gives me a whole different tension. [ATTACH=CONFIG]603149[/ATTACH]
So, which one is right? Is there something wrong with my bobbin case? Or do I just adjust my tension right off the bat for the thread having slipped down out of the hook? Is there a way to fix the hook?
Thanks, Watson
I'm having trouble with tension lately. I can't seem to get it to stay equal. Usually I've got front thread on the back regardless of how I adjust the top tension, even when the bobbin tension says it is correct.
I've noticed something on my bobbin. When I load my bobbin into the casing, I always make sure the thread is around the little hook. First picture. [ATTACH=CONFIG]603148[/ATTACH] And that is what I tension my bobbin for, using Jamie Wallen's technique.
If I take my bobbin out halfway for whatever reason, I notice the thread is no longer around the hook but has slipped down as in the second picture, and that gives me a whole different tension. [ATTACH=CONFIG]603149[/ATTACH]
So, which one is right? Is there something wrong with my bobbin case? Or do I just adjust my tension right off the bat for the thread having slipped down out of the hook? Is there a way to fix the hook?
Thanks, Watson
#2
I've always pulled my thread past the hook. I do that for every single machine I have with that type of bobbin case and always have. I'm sure all my directions for assorted machines show doing it that way. After all, that is where the tension is applied, if you don't slip it past the hook it may pop out and then you'll have no tension. I've had that happen a time or two with the LA.
#7
I was having uneven tension problems and after I bought the towa gauge, I discovered that the five bobbins that came with my HQ did not turn evenly in the bobbin case. When I pulled, the tension would bounce around about 50 points. Once I stopped using them, that uneven tension problem went away.
BTW - the bobbins I got with the machine were very different than what HQ is selling now. They were quite a bit thicker and heavier.
BTW - the bobbins I got with the machine were very different than what HQ is selling now. They were quite a bit thicker and heavier.
#8
Super Member
Join Date: Aug 2009
Location: Illinois
Posts: 1,806
#10
Super Member
Join Date: Aug 2015
Location: Central Texas
Posts: 1,310
My sister has had issues; the shop told her that even if you drop the case on carpeting it can be bent - just enough to mess up the tension. So if you've dropped it and have even carpet - I'd think tile and hard wood floors would be even worse for it then it might not be quite 'round', so might need to be replaced. I'm not sure there is a way to make them perfectly round again.
Thread
Thread Starter
Forum
Replies
Last Post
J Miller
For Vintage & Antique Machine Enthusiasts
4
01-20-2013 01:48 PM