Two Questions
#11
Super Member
Join Date: Jun 2008
Location: British Columbia
Posts: 2,352
This intrigues me, using a seam ripper never seemed to happen in a certain way. But now that I think about it, my preference is to pick carefully between the two pieces. By carefully, I mean don't pull the thread or the fabric but gently cut the thread three or four stitches away from the opening then loosen to the cut and continue on. I find that this way I end up with one thread not cut making it easy to pull out one long thread. It also makes the thread obviously different from the fabric.
#14
Originally Posted by Jannie
Slide the seam ripper under a stitch & then again 3 or 4 stitches away. Keep doing this until the end. Then you pull the thread on the other side of the seam & you are ready to redo the seam the right way!! Hope this makes sense.
#15
Super Member
Join Date: Jul 2008
Location: Maple Grove, MN (by way of GA, NC, PA, NC, AL!)
Posts: 1,548
Originally Posted by Jim's Gem
Yea, you don't want to stretch or accidentally cut the fabric by pulling it apart real hard to clip the threads. I pick on side (usually the one I can see better) and snip every 4 threads or so. then turn over and pull on the thread you did not snip and it should pull right out. Use a piece of tape to collect all the little snippets of thread left in the fabrics.
#16
Originally Posted by Renee
Oh my goodness you guys are too silly!! LOL
Let me be more specific.......Okay, I've sewn my two pieces together and realized I goofed. Do I use the seam ripper to pull the sewn line out on the outside of the fabric or do I open up my sewn pieces and use the seam ripper down the middle of the two? Does that make more sense?
Let me be more specific.......Okay, I've sewn my two pieces together and realized I goofed. Do I use the seam ripper to pull the sewn line out on the outside of the fabric or do I open up my sewn pieces and use the seam ripper down the middle of the two? Does that make more sense?
#19
Banned
Join Date: Jul 2007
Location: northern New England
Posts: 459
Just be glad seam rippers have evolved to what they are today. This is one of Singer's needle threader/seam ripper combo tools from the 50's. I used to use just a single edge razor blade...it goes pretty fast that way! :roll:
#20
Power Poster
Join Date: May 2008
Location: MN
Posts: 24,645
Originally Posted by Oklahoma Suzie
I have used both ways for the seam ripper. I do think I will look into getting the one from Clover. I do need a sharper one.
Thread
Thread Starter
Forum
Replies
Last Post
IBQUILTIN
General Chit-Chat (non-quilting talk)
10
07-10-2015 09:59 AM