Green Ribbon top done :) :)
04-19-2009, 07:18 PM
#13
Junior Member
Join Date: Feb 2009
Location: Guymon, OK
Posts: 113
I have used both and haven't had any problems with them. But I also use Bubble Jet rinse on them before I put them on the the quilt. Let the ink dry, then rinse in cold water to make sure the ink has set, will do the same. I always let them dry out flat on a towel, when dry I press with a dry iron, iron on the back the quilt. For extra protection I usually blind stitch around the lable as well.
04-19-2009, 07:26 PM
#15
Super Member
Thread Starter
Join Date: Feb 2009
Location: MI
Posts: 2,526
Okie3, Is that two different methods your talking about? You use Bubble Jet rinse with the transfer sheets and with print to cloth? Or can I just rinse either method in cold water to set the ink?
Sorry for being dense, but I've never printed a label before. I've read a lot on here about doing them, but didn't retain much of it apparently. lol!!!
Thanks! :-)
Sorry for being dense, but I've never printed a label before. I've read a lot on here about doing them, but didn't retain much of it apparently. lol!!!
Thanks! :-)
Thread
Thread Starter
Forum
Replies
Last Post
Julie in NM
General Chit-Chat (non-quilting talk)
2
11-09-2011 07:30 PM
