Go Back  Quiltingboard Forums > Pictures
So what went wrong? >

So what went wrong?

So what went wrong?

Thread Tools
 
Old 10-18-2010, 08:37 AM
  #11  
Banned
 
Join Date: May 2010
Location: Midwest
Posts: 527
Default

It looks like your quilt was tied. This allows for a lot more wiggle room in the washer/dryer and will allow the seams of a loosly woven fabric to fray apart.

So, When piecing with flannel I take 1/2 inch seams instead of 1/4 inch seams especially if you ar going to tie it rather than quilt it.

Quilting will help prevent this, even if its just in the ditch quilting.
JCquilts is offline  
Old 10-18-2010, 08:40 AM
  #12  
Senior Member
 
quilting Carol's Avatar
 
Join Date: Mar 2010
Location: Decatur,Indiana
Posts: 410
Default

I agree with Azwendyg...and you tied it so that gives it a lot of wiggle room. Does you washer have a agitator? that will give it more room to pull seams apart; you could in addition to pre-washing fabric surge the seams to lock them...Sorry that it happened. I have seen it happen a lot. I save flannel for raggy shaggy quilts or backs where it isn't cut up a lot.
quilting Carol is offline  
Old 10-18-2010, 08:46 AM
  #13  
Super Member
 
Join Date: Apr 2007
Location: North Carolina - But otherwise, NOTW
Posts: 7,940
Default

Is it flannel? Good idea is to use good 1/2" seams on flannel...it's very unpredictable in the ravelling. I would pink all the edges of flannel. Also, you must wash it all before in warm and dry it hot to get it all to shrink. Flannel is such a pain, I don't use it much at all. So sorry this happened to your quilt...it is really cute!!
jljack is offline  
Old 10-18-2010, 08:57 AM
  #14  
Senior Member
Thread Starter
 
angieh1964's Avatar
 
Join Date: Mar 2010
Location: Dennison Ohio
Posts: 401
Default

no the back is the only flannel and did not fray at all the front is all cotton fabric dont use any other on baby quilts i will be doing a finishing zig zag seam from not on. and the hand tied was not it i hand tied the last two which were about half flannel and half cotton a few little frays here and there but this is almost the WHOLE quilt top. i am hoping joanns will do something not holding my breath but i can hope
angieh1964 is offline  
Old 10-18-2010, 09:10 AM
  #15  
Junior Member
 
ShySally's Avatar
 
Join Date: Oct 2010
Location: Sevierville TN
Posts: 173
Default

make sure the 1/4 is on both side of your material, some time when we sew it will slips.
ShySally is offline  
Old 10-18-2010, 09:49 AM
  #16  
Power Poster
 
Join Date: Oct 2009
Location: Idaho
Posts: 11,375
Default

I am so sorry this happened. I would try SID along with/or without the ties to anchor it in place.
Sadiemae is offline  
Old 10-18-2010, 10:05 AM
  #17  
Super Member
 
Join Date: May 2010
Location: Washington state
Posts: 4,303
Default

I think what happened is that you may not have had a good , at least 1/4 inch seam allowance and the quilt appears to be tied. Looks like it was not tied close enough and when the washing machine agitated the fabrics pulled more since the tying was so far apart. When you read on the batting packages how far apart the quilting needs to be, at a minimum, I think same might apply for the tying. Too much pulling on the fabrics during the washing process.
Lilrain is offline  
Old 10-18-2010, 10:13 AM
  #18  
Senior Member
Thread Starter
 
angieh1964's Avatar
 
Join Date: Mar 2010
Location: Dennison Ohio
Posts: 401
Default

i did wash it by itself maybe should have put another blanket or something else with it
angieh1964 is offline  
Old 10-18-2010, 10:31 AM
  #19  
Power Poster
 
Join Date: Feb 2009
Location: Northern Michigan
Posts: 12,861
Default

when ever i use flannel (or any heavier than cotton fabric) i adjust my pattern and use 1/2" seams. one way to make sure you have the top and bottom even for piecing you should have the bottom fabric show just a thread or two beyond the top piece that way when you sew you know the back is caught in the seam just as well as the top. also, prewash flannels. thin, loose weave, single sided flannels fray the most, if possible always try to find the thicker double sided flannels. but i think if you make sure your fabrics are evenly together and you use a wider seam you will not have this problem anymore.
ckcowl is offline  
Old 10-18-2010, 10:35 AM
  #20  
Super Member
 
mary quite contrary's Avatar
 
Join Date: Aug 2008
Location: Georgia
Posts: 2,524
Default

I'm so sorry this happened to you.
mary quite contrary is offline  
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
bee3
Main
8
07-07-2014 02:47 PM
Smg1678
Pictures
52
02-26-2013 07:19 PM
Twisted Quilter
Main
63
01-16-2010 03:54 PM

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is On
Trackbacks are Off
Pingbacks are Off
Refbacks are Off



FREE Quilting Newsletter