Appliqué scissors recommendations?
#13
The Kai “Patchwork” scissors are the bomb. They have a serrated edge, which is great for grabbing the fabric as you’re cutting curves. The smoothest curves I’ve ever cut. Lost one pair and replaced them immediately. I really like the 4” for smaller pieces, and the 6” for larger applique. Kai 3120 4 3/4 Inch Serrated Blade Patchwork Scissor https://www.amazon.com/dp/B0094429Z2..._a-WrBbTAXAQG9
#14
Senior Member
Thread Starter
Join Date: Feb 2015
Posts: 410
It depends on the type of applique. I like small thin ones for cutting out fused applique like the second pair shown here (green 4 inch).
For machine EMB applique I like these. They get into tight corners. I hold the fabric almost straight up and trim close.
http://www.havelssewing.com/snip-eze...ors-33010.html
I don't like the duck bill ones for machine EMB as I don't get close enough.
For machine EMB applique I like these. They get into tight corners. I hold the fabric almost straight up and trim close.
http://www.havelssewing.com/snip-eze...ors-33010.html
I don't like the duck bill ones for machine EMB as I don't get close enough.
#15
Senior Member
Thread Starter
Join Date: Feb 2015
Posts: 410
Kari are the best I have come across not terribly expensive and come in several sizes. My preference are straight blade four inch I think they are the smallest, better than my Ginger’s also handle fusible appliqué well too. They cut a very clean line. A curved blade is available too although not my personal preference. Good luck
#17
For cutting shapes for traditional applique, my choice is the finely serrated scissors by Karen Kay Buckley. I'm not a fan of curved scissors, but I have all 3 of her straight bladed ones and love them!
#18
Senior Member
Thread Starter
Join Date: Feb 2015
Posts: 410
Thanks, Rob, my shears are Gingher and I love them beyond what is reasonable for a pair of scissors. I tried some others but I always go back to those. I didn't even think of Olfa, but now I am.
#20
Senior Member
Thread Starter
Join Date: Feb 2015
Posts: 410
I do a lot of machine embroidery applique, and just machine embroidery in general. I use squeezers, same thing as the Havels link shown above. I have straight blade and curved blade ones, different brands bought from different places. After using these just once I bought a pair to have at every machine in use in the house. If you have arthritis in your hands these are so much easier to use than scissors. For applique I use the curved blade, it allows me to get right up the threads without cutting through them.
Cari
Cari
Thread
Thread Starter
Forum
Replies
Last Post