Hi from Minnesota.
#12
Member
Thread Starter
Join Date: Jul 2022
Location: New Ulm, MN
Posts: 5
Hi Tartan.
Tartan has great idea to add layers of rubber or foam to bring up the height. I will keep that in mind! I did talk to Creative Sewing and they told me how to try to micro adjust the table height, just have to buy a socket set. If that fails I will do the foam!
#15
Member
Thread Starter
Join Date: Jul 2022
Location: New Ulm, MN
Posts: 5
Finally, Success! Fixed the Koala table height!
Woo-hoo! Succeeded in micro adjusting the Koala manual table height. Only took $50 investment in rachet set and 3 trips to hardware store, flashlight, 6 inch ruler to figure out just how much higher the table needed to go, my daughter to push down on table while holding the flashlight, while I contorted my 62 yr old body underneath and 1 feline inspector monitoring the entire process. Hope I NEVER have to do this again....
#17
Super Member
Join Date: Jul 2019
Location: northern minnesota
Posts: 2,480
Woo-hoo! Succeeded in micro adjusting the Koala manual table height. Only took $50 investment in rachet set and 3 trips to hardware store, flashlight, 6 inch ruler to figure out just how much higher the table needed to go, my daughter to push down on table while holding the flashlight, while I contorted my 62 yr old body underneath and 1 feline inspector monitoring the entire process. Hope I NEVER have to do this again....
#20
The adjustment was so easy. I've put up with an uneven sewing surface for YEARS because I did not know about the adjustment.. Thank you so much!