Where there is a wil, there is a way!
#65
Member
Join Date: Dec 2010
Location: Collierville, TN
Posts: 61
Ok cut it to fit around the whole machine! Make your machine fit all the way inside the cut. That way it does not fall off that little back edge. If you look at the tables where your machine inserts the custom plexiglass things fit all the way around the machine. Just a thought but it would make it even better. And if you could cut a hole in your table and set it inside even better. Where there is a will there is a way!!
#68
[It also helps to tape plexiglass with masking tape when cutting it. I make lot of my own templates useing plexiglass,such as squares dimonds,triangles etc.[/quote]
After you mask it off what kind of saw do you use to cut it?
After you mask it off what kind of saw do you use to cut it?
Thread
Thread Starter
Forum
Replies
Last Post
nantucketsue
Main
12
06-01-2012 08:07 PM
Lizzygail
General Chit-Chat (non-quilting talk)
4
01-03-2010 09:07 AM