Dresden Plate Block with round edges
#1
Dresden Plate Block with round edges
I made 12 plates with round edges and now I want them on the background fabric. I know that I read somewhere, (maybe Eleanor Burns), how to sew something on it and then turn it inside out. I'm not crazy about anything that would add extra weight and I tried the hand sewing. Trying to turn those round edges didn't look good. I've been trying to read everything I can on the Internet but mostly the plates have pointed edges. Can anyone give me suggestions as I'm trying to finish my UFOs. Thanks.
#3
Senior Member
Join Date: Apr 2017
Location: Gilbert, AZ
Posts: 985
You could put your background fabric on the Dresdens with right sides facing, then machine sew around your circle. Pull them apart in the middle and cut the excess fabric from the center leaving a seam allowance. Then flip it right side out. Just be careful not to cut through your Dresdens. Should give you a perfect circle.
#5
You could put your background fabric on the Dresdens with right sides facing, then machine sew around your circle. Pull them apart in the middle and cut the excess fabric from the center leaving a seam allowance. Then flip it right side out. Just be careful not to cut through your Dresdens. Should give you a perfect circle.
Thank you for this suggestion, I think this is what I saw years ago. I know I could sew it with invisible thread around the edges, but I really didn't want to do that this time. Thanks everyone.
#7
Senior Member
Join Date: Jun 2017
Location: California
Posts: 441
I suggest this method: http://www.sewmuchlikemom.com/2013/0...ards-path.html
i find it much easier than using interfacing, you won't have the extra weight, and your circles will be perfect so long as you cut your freezer paper right.
i find it much easier than using interfacing, you won't have the extra weight, and your circles will be perfect so long as you cut your freezer paper right.
#9
Super Member
Join Date: Jun 2011
Location: Illinois
Posts: 9,018
If your plate is solid circle, the flip and sew method would work, but if your plate has scalloped wedges, might be tricky. I read somewhere - a while back - from heat resistant Mylar, draw your template scallop and down about an inch that you used for fabric, then measure in 1/4" for the "finished" edge-- that's the line you cut this template out at. Hopefully when you joined the wedges, you stopped 1/4" from that scallop edge.....anyway...put this onto back side of each wedge, iron over, move to next.....then you can blanklet stitch, invisible thread stitch, or straight stitch onto background....it takes a bit of time, but whose in a hurry!
Thread
Thread Starter
Forum
Replies
Last Post
craftybear
Links and Resources
0
03-18-2011 06:03 PM
craftybear
Links and Resources
1
03-11-2011 07:23 AM
craftybear
Links and Resources
11
02-15-2011 09:33 PM