Leveling a studio 2 from from HQ
#1
Super Member
Thread Starter
Join Date: Jan 2011
Posts: 2,039
Leveling a studio 2 from from HQ
i was wondering if someone could explain how I level my frame. I asked my representative and he told me. I need to get on my hands and knees and turn a screw with the special screw driver. My question? which screw driver and what screws needs to be turned , another words, where exactly is the screw located. My machine drifts forwards. Any help and pics would be perfect. Thank-you in advance.
#2
Super Member
Join Date: May 2012
Location: S.E. Queensland, Australia
Posts: 1,461
There is a tiny section in this video , at 17.10 on how to level the frame.
https://www.youtube.com/watch?v=DQkvi_EKMI8
https://www.youtube.com/watch?v=DQkvi_EKMI8
#3
Super Member
Join Date: Nov 2010
Location: Utah
Posts: 2,072
The flat wrench in the video is the correct tool to use. The nut that you adjust is just above each foot, and there are 8 of them. To lower the frame, you'd turn it to the left. Usually to tighten is "righty-tighty," but you are looking at it from the top, not from the bottom. To raise the frame, you'd turn to the right. Here's a picture.
Thread
Thread Starter
Forum
Replies
Last Post
Krystyna
Mission: Organization
54
11-25-2015 02:36 PM
Diamonds
Main
6
05-17-2008 10:48 AM