Design helper and hexagons
02-14-2024, 02:46 AM
#1
Member
Thread Starter
Join Date: Apr 2023
Posts: 1
Design helper and hexagons
Hi, can anyone help. I use a large pattern fabric with anything from 14 to 18" repeat, 44" wide fabric with triangles at 3.75 as suggested, however my hexagons never turn out like the ones the design helper shows for the same fabric
02-14-2024, 06:04 AM
#4
Super Member
Join Date: Mar 2015
Location: Denver, CO
Posts: 4,285
I'm guessing you are using https://oneblockwonder.com/design-helper/ Are you layering when you cut the strips? There is also an option to "Turn All" after you have put your fabric repeat and measurements in.
Another possibility is that since they are equilateral triangles, it would be possible to turn some so that they don't have the same pattern at the center point.
Another possibility is that since they are equilateral triangles, it would be possible to turn some so that they don't have the same pattern at the center point.
02-14-2024, 06:18 AM
#5
Super Member
Join Date: Dec 2017
Posts: 1,866
If you are using https://oneblockwonder.com/design-helper/, double check that you have entered the correct size for the width of image. It defaults to 40" width, so if your image is showing only 20" of fabric, it will show you a very different size (and count) of triangles/hexagons than if you enter the correct width.
Additionally, I believe that this tool does *not* account for seam allowances; it shows you hexagons as they would appear if you put them together with raw edge applique (or something else similar) rather than sewing them together with a 1/4" seams.
Additionally, I believe that this tool does *not* account for seam allowances; it shows you hexagons as they would appear if you put them together with raw edge applique (or something else similar) rather than sewing them together with a 1/4" seams.
