Macybaby

I read all the time where people say to be careful to PRESS when quilting instead of IRONING. Now, I've been sewing for 50 years, and have done things from doll clothes to wedding gowns, from lingerie to auto upholstery and lots of alterations. I started quilting in the last few years.

And I still can not figure out what the difference between ironing and pressing is. I do not think I use my iron any differently with quilting than other types of sewing, except that I prefer a dry iron when quilting. I also never use starch.

So - what is the difference between ironing and pressing? I'm starting to think I only know how to press, and have never learned how to iron.

ManiacQuilter2

When you are pressing, you are coming straight down onto the fabric. You are taught not to press like you would a man's shirt since you can distort the exact size of a block especially if the edges are bias. Hope that makes sense.

cjsews

When you iron you are moving your iron from side to side. This moves the fabric and can stretch the fabric out of shape. If you see a block and have all your cutting and seams accurate you can end up with a block that is not squared up after ironing. Pressing is setting your seams to the side or open without stretching the fabric. I found that if I use the tip or edge of my iron on these seams I get less distortions

joe'smom

With ironing, you move the iron with the weight of the iron on the fabric. I iron my fabric along the length of grain when preparing it for cutting.

With pressing, you don't move the iron with the weight of the iron on the fabric. You lift the iron off the fabric to move it, place it down in one position, and then lift it again to move it to a different position.

tessagin

when I iron/press, I give the fabric a bit of a shake and let it rest. Like when I had to iron pillowcases and the tops of flat sheets while still home. God bless the perma/press inventor. Never understood because we had bedspreads to cover entire bed.

bearisgray

I think of "pressing" as bringing the iron down to one spot - and leaving it on that spot for a few seconds - then lifting it up and putting it down in another spot.

When it comes to my quilting pieces - I "press" to set the seams - and then turn the piece to the right side to "iron" the seam to one side (usually). Because I am a fanatic about grain lines - and iron "with the grain" - I seldom have distortions on my blocks.

Onebyone

Pressing is putting the iron down and then lifting it up. No movement. Like you were using a pants press. .
I have this one and it is wonderful for quilting. http://www.walmart.com/ip/17167251?w...118271&veh=sem I bought one on the clearance aisle for $39.99 several years ago. Keep a look out for one at sales. It's worth having.

jclinganrey

As others have said, ironing is back and forth and pressing is up & down.

RedGarnet222

If there is a stubborn seam and it needs extra heat but you are afraid the iron will burn your fabric, you can also use a wooden clapper after lifting the iron, just set the clapper down and it holds the heat in.

The reason that scrubbing is a bad thing is because the bias is very temperamental. It can sometimes stretch/distort a block by the smallest motion. Many quilters don't use steam for the same reason.

EasyPeezy

Here's a very interesting video on how to press HST's.
http://https://www.youtube.com/watch?v=CynQMi2IQ18