KarenJ

I've been using the same set of Fiskars square rulers for years, 12 1/2, 9 1/2, 4 1/2 etc. They all have the 1/4" seam allowance on 4 sides of the ruler. Looking at the newer ones, various brands, they all have a 1/2" seam allowance on 2 sides and no allowance on the other 2. Why? It seems it would be difficult to use these to square up blocks since one would have to offset the center point and any angles or seam lines by 1/4 inch in order to trim.
Maybe it's just me.....but I don't understand the purpose of the 1/2" on 2 sides or how you would use these. Enlighten me, please.............

EasyPeezy

It's what you are used to. I've always had rulers with the extra 1/2".
In fact I like to use a bigger ruler for squaring. If I need to square
a 10.5" square block I use the 12.5" square, etc.

quiltingnewf

I would like to know the reasoning behind the design too. I have one of these rulers too. I purchased it as a set, (mat ruler and cutter) from Michael's with a coupon thinking of the savings. It wasn't really a bargain as I ended up buying another ruler

Dee

GingerK

Does your ruler have a 1/4 inch mark and then the inches mark and at the other end, another 1/4 inch mark?

Jan in VA

Rulers are like tire sizes. They may look the same but are often not the same size or markings.

charlottequilts

I love the 1/2" on the side of the Omnigrid rulers. Here's why: when you are measuring an even increment of inches, it is ever so much easier to line up along the 1/2" mark than at the 1". There are fewer lines and it's easier to see if you're exactly on the mark. For 1.5", I use the "even inch" side, thereby landing again in the middle of the marks and not on the even inch. I spin the ruler around often, but it's easily done,

charlotte, hoping this makes sense

QuiltnLady1

When I first started using the Omnigrid rulers, it was hard to get used to the "extra" half inch. I still think about it now and then, but I am used to it now -- mostly.

Mitty

I always thought that they make them that way because full inches and half inches are the most common measurements. For squaring up a block, there's 1/4" seam allowance on both sides - if your finished block is 8", then your unfinished block will be squared up to 8 1/2". I guess it depends if you're measuring from the middle of the block or the whole block. Some blocks don't have a middle seam to measure from.

Claire123

I think many of the newer rulers are less likely to slip. I hadn't really noticed or thought about the 1/2" on the 2 sides...

Onebyone

Quilter's Select square rulers do not have the 1/2" added.