Anyone know which machine these cams would fit?
#1
Super Member
Thread Starter
Join Date: May 2010
Location: Ontario, Canada
Posts: 1,779
Anyone know which machine these cams would fit?
I was looking around different sites and came across these
http://www.ebay.com/itm/Vintage-24-D...item27e2323984
Does anyone know which machine they would be for? Good price and cute box!
http://www.ebay.com/itm/Vintage-24-D...item27e2323984
Does anyone know which machine they would be for? Good price and cute box!
#2
Super Member
Join Date: Aug 2013
Location: Springfield Oregon
Posts: 1,481
deluxe made so many variations. It probably will fit several badged machines, liss morse dressmaker or white, but not sure which specific models. I'm looking for a simila set but instead of an off center hole to locate on a drive pin, my deluxe princess needs obround slot in the end. havent found any yet..
#5
Power Poster
Join Date: Mar 2011
Location: Somewhere
Posts: 15,506
This afternoon I had a Brother and a White out looking at the cams. The Brother has a set of cams almost like that. The White needs a set of cams so I tried to see if they would interchange. NOPE. The shaft was slightly larger on the White. Just a hair and the hole is slightly different. There is no way of knowing if a cam will fit until you try it on the shaft.
#7
Senior Member
Join Date: Aug 2010
Location: Beaverton,Michigan
Posts: 802
deluxe made so many variations. It probably will fit several badged machines, liss morse dressmaker or white, but not sure which specific models. I'm looking for a simila set but instead of an off center hole to locate on a drive pin, my deluxe princess needs obround slot in the end. havent found any yet..
#9
Super Member
Join Date: Aug 2013
Location: Springfield Oregon
Posts: 1,481
Thanks for the cams Miriam. It's amazing the minor and major variations the same mfr went thru on these. The ones you sent me, were for a little larger shaft. So what I did was made an adapter bushing from Delrin on my lathe. The rectangular locating tip was also a little larger, and I didn't do anything about that. They do seem as though they will work fine. A little snug getting them back out of the SM, had to use to paint can openers to grab and lift with.
Thread
Thread Starter
Forum
Replies
Last Post
J Miller
For Vintage & Antique Machine Enthusiasts
4
11-06-2015 12:32 PM
Hummer Lady
For Vintage & Antique Machine Enthusiasts
8
03-21-2015 09:54 AM
Ccorazone
For Vintage & Antique Machine Enthusiasts
1
04-25-2012 02:27 PM
sunnyhope
Main
9
04-20-2009 11:46 AM