Cleaned my Bernina 707 motor... but now pedal is not working!
#1
Senior Member
Thread Starter
Join Date: Jul 2013
Location: Montreal, Quebec, Canada
Posts: 459
Cleaned my Bernina 707 motor... but now pedal is not working!
Ok, I decided to clean the motor of my Bernina 707 this morning. One of the carbon brush was worn off to the spring and there was a lot of black dust. So I carefully dismantled everything, cleaned the commutator with an eraser, put new carbon brush and put everything back where it was. I was so proud of myself...
When I plugged the machine, the light was ok. But when I pressed the foot pedal... nothing happened.
I assume I must have put something back in a wrong way, but before opening it all again, I would like to have some clue about what could be wrong. A twisted wire? A loose screw? Would appreciate any idea.
When I plugged the machine, the light was ok. But when I pressed the foot pedal... nothing happened.
I assume I must have put something back in a wrong way, but before opening it all again, I would like to have some clue about what could be wrong. A twisted wire? A loose screw? Would appreciate any idea.
Thread
Thread Starter
Forum
Replies
Last Post
Sewhere
For Vintage & Antique Machine Enthusiasts
12
12-13-2018 06:58 PM
pkayhaynes
For Vintage & Antique Machine Enthusiasts
6
05-06-2018 08:39 AM
torienby
For Vintage & Antique Machine Enthusiasts
4
04-19-2018 03:59 PM