Loud noise from 15-91 in body area
#1
Member
Thread Starter
Join Date: Jun 2020
Posts: 3
Loud noise from 15-91 in body area
Hello,
I just picked up this machine and did all the oiling, cleaning and lubing per the tutorials here and video found online. I have 2 issues that I can’t figure out and hope you can help me.
1) There is a noise coming from the body area where the stitch length lever is. All the hardware is tightened and oiled, but I can’t figure out this noise for the life of me and when the machine is at an angle the noise goes away.
2) The stitch length lever bounces around. Not sure what’s happening there.
Please take a look at the video to see what I’m talking about.
https://youtu.be/IhSzkT6bszI
Thanks for your advice.
I just picked up this machine and did all the oiling, cleaning and lubing per the tutorials here and video found online. I have 2 issues that I can’t figure out and hope you can help me.
1) There is a noise coming from the body area where the stitch length lever is. All the hardware is tightened and oiled, but I can’t figure out this noise for the life of me and when the machine is at an angle the noise goes away.
2) The stitch length lever bounces around. Not sure what’s happening there.
Please take a look at the video to see what I’m talking about.
https://youtu.be/IhSzkT6bszI
Thanks for your advice.
#2
Super Member
Join Date: Sep 2015
Posts: 1,963
Maybe someone else has had a similar problem with a 15, the closest I have had is packed up dust under the throat plate, it sort of gives similar problems with stitch length and lever. Regardless, since it's a newly required machine I would keep on oiling every joint, hinge and gear; if you are lucky the trouble might be caused by a stuck part some where. I would pay particular attention to every link from stitch length lever to feed dogs; repetetive oiling, and investigating under good ligh conditoins, like torch or reading lamp.
A dry machine can need quite a bit of oiling to run well again, I have had to keep oiling for up to four days to free up a machine and it was just a bit sluggish to start with. You might need to get the hand wheel off to get to the grease parts behind the hand wheel, there is a worm gear that needs to be checked. Poke a tooth pick down the holes on top, and make sure you detect all the oil points, it's easy to miss a few. Every part where metal moves against metal needs lubrication.
A dry machine can need quite a bit of oiling to run well again, I have had to keep oiling for up to four days to free up a machine and it was just a bit sluggish to start with. You might need to get the hand wheel off to get to the grease parts behind the hand wheel, there is a worm gear that needs to be checked. Poke a tooth pick down the holes on top, and make sure you detect all the oil points, it's easy to miss a few. Every part where metal moves against metal needs lubrication.
Last edited by Mickey2; 06-07-2020 at 03:10 PM.
#4
Junior Member
Join Date: Jan 2020
Location: Ontario
Posts: 299
Looking at the video, the position of the feed forked connecting rod and the feed regulator (stitch length mech), it looks off. Binding can occur when the shoulder of the slideway part of the feed regulator is pressed against the feed fork. Hopefully nothing is damaged and merely been took apart and reinstalled out of balance. Hope this helps.
ps: what you need is the 15-91 adjusters manual
ps: what you need is the 15-91 adjusters manual
Last edited by Hooligan; 06-07-2020 at 10:02 PM.
#6
Super Member
Join Date: Nov 2006
Location: las vegas nv.
Posts: 2,452