Singer 58' 185 K3
#1
Super Member
Thread Starter
Join Date: Nov 2010
Location: Morganton, North Carolina
Posts: 2,882
Singer 58' 185 K3
Picked her up at the local flea-market for $25 Clean as a whistle, and purrrrrrs like a
kitten......beautiful, yummy green.......well poop, I've tried 5 times to load the pic....just won't let
me....I'll try for a pic later. Just wanted to let someone ( who'll appreciate her ), know that I got a new
baby.... her name is Boop...after the GREAT Betty Boop
kitten......beautiful, yummy green.......well poop, I've tried 5 times to load the pic....just won't let
me....I'll try for a pic later. Just wanted to let someone ( who'll appreciate her ), know that I got a new
baby.... her name is Boop...after the GREAT Betty Boop
#6
Banned
Join Date: Oct 2009
Location: Bikini Bottom
Posts: 5,652
Billy
#7
Probably not sitting all of the way in the spring, to take it off you have to pull it back a tad then lift the front and push it over the needle plate. Then take a small screwdriver and help the spring into both sides of the plate. Also while you have it off you can clean the area up a bit just in case there was dust or dirt under it or in the area of the plate.
Billy
Billy
Thank you Billy, I'll give that a try.
#8
Super Member
Thread Starter
Join Date: Nov 2010
Location: Morganton, North Carolina
Posts: 2,882
Maybe it's operator error on my part
#9
Senior Member
Join Date: Aug 2011
Location: western NC
Posts: 491
The plate has to go on from right to left-I know it sounds wrong. Start from the needle side and using Billy's instructions from above for the spring, push it to the left. It may take more than one try. Good luck!
Pat
Pat
Thread
Thread Starter
Forum
Replies
Last Post