where should these wires go?
#1
Senior Member
Thread Starter
Join Date: Jul 2017
Posts: 809
where should these wires go?
This is the knee controller built into the cabinet for my Kenmore 117.xxx. I'd like to use it instead of the foot pedal currently attached to the machine, but I'm not sure how to wire them. Thanks for the help. computer has the uncontrollable scrolling disease, so doing things is difficult.
[ATTACH=CONFIG]585968[/ATTACH]
[ATTACH=CONFIG]585969[/ATTACH]
[ATTACH=CONFIG]585967[/ATTACH]
[ATTACH=CONFIG]585968[/ATTACH]
[ATTACH=CONFIG]585969[/ATTACH]
[ATTACH=CONFIG]585967[/ATTACH]
#2
[ATTACH=CONFIG]585990[/ATTACH]
If you have a single two-wire cord going to your foot controller, the easiest thing to do would be to open the foot controller, disconnect the two wires and connect them to terminals A and B. It doesn't matter which wire to which terminal.
John
If you have a single two-wire cord going to your foot controller, the easiest thing to do would be to open the foot controller, disconnect the two wires and connect them to terminals A and B. It doesn't matter which wire to which terminal.
John
Thread
Thread Starter
Forum
Replies
Last Post
quilt938
For Vintage & Antique Machine Enthusiasts
19
07-06-2015 05:21 PM
Mrs. SewNSew
For Vintage & Antique Machine Enthusiasts
4
03-23-2015 05:03 AM
ArizonaKAT
For Vintage & Antique Machine Enthusiasts
10
05-08-2013 09:59 AM