White vs III

Reply Subscribe

Page 2 of 2

Thread Tools

02-23-2018, 07:35 AM

#11

Barb in Louisiana

Super Member

Join Date: Jun 2010

Location: The Deep South near Cajun Country, USA

Posts: 5,385

It sure is a pretty machine even in the shape that it is in. I don't restore old machines, but I sure do admire them and they make wonderful paperweights. Hope you get it going.

02-23-2018, 09:07 AM

#12

Rocsew

Member

Join Date: Aug 2017

Location: Western NY

Posts: 57

leonf, sure, let me know.

02-23-2018, 10:09 AM

#13

Puffie40

Member

Join Date: Feb 2018

Posts: 29

Quote:

Originally Posted by leonf

[ATTACH=CONFIG]589427[/ATTACH]

Given what warrant mean nowadays, does this mean it's on the lam? :P

02-23-2018, 03:47 PM

#14

leonf

Super Member

Thread Starter

Join Date: May 2016

Location: near Topeka kansas

Posts: 4,524

Rocsew, Was there anything beisdes the set screw holding the wheel with the clutch arm to the crankshaft?

Thanks. Mly rotaries have a threaded screw in the middle.

02-24-2018, 05:31 AM

#15

Rocsew

Member

Join Date: Aug 2017

Location: Western NY

Posts: 57

leonf, It's been a while since I took that off, but I think there was just the set screw. FWIW to get stubborn handwheels off I'll put a piece of 2x under the needlebar to stop the shaft from turning and then "screw" the wheel off, rather than pulling it straight out. You might even be able to use a pipe wrench on the smaller piece (be gentle natch).[ATTACH=CONFIG]589644[/ATTACH]

Attached Thumbnails