Viking Sapphire 870 Quilt machine question
05-09-2018, 01:28 PM
#1
Member
Thread Starter
Join Date: May 2018
Posts: 1
Viking Sapphire 870 Quilt machine question
Just registered for this site and look forward to utilizing the forums when I have questions.
So, first question...which setting works best on this machine for 1/4" seam? The default setting when the machine is turned on? If so, which foot works best? OR the 1/4" setting which can be selected on the graphic display? If so, which foot works best?
Second, using either do you prefer a foot with the 1/4" guide?
Looking forward to responses. Thanks in advance.
So, first question...which setting works best on this machine for 1/4" seam? The default setting when the machine is turned on? If so, which foot works best? OR the 1/4" setting which can be selected on the graphic display? If so, which foot works best?
Second, using either do you prefer a foot with the 1/4" guide?
Looking forward to responses. Thanks in advance.
05-09-2018, 02:15 PM
#4
Power Poster
Join Date: Dec 2010
Location: Michigan
Posts: 11,276
Welcome to the board!
The thing you need to keep in mind is that although we talk about a quarter inch seam, you don't measure the seam, you measure the resultant patch. Here's how to check:
Achieving an Accurate 1/4" Seam Allowance
Fabric and thread thickness can affect needle placement. I often double check at the beginning of a project to make sure that my needle position is correct for that fabric/thread combo. I have a Viking, use the metal foot with a flange and usually have to move the needle to the right, usually at the 1.8 or 2.0 position.
The thing you need to keep in mind is that although we talk about a quarter inch seam, you don't measure the seam, you measure the resultant patch. Here's how to check:
Achieving an Accurate 1/4" Seam Allowance
Fabric and thread thickness can affect needle placement. I often double check at the beginning of a project to make sure that my needle position is correct for that fabric/thread combo. I have a Viking, use the metal foot with a flange and usually have to move the needle to the right, usually at the 1.8 or 2.0 position.
05-09-2018, 04:29 PM
#5
Super Member
Join Date: Jun 2007
Location: British Columbia
Posts: 8,044
I have the Sapphire 870Q and use the ¼ " foot part # 412-7855. And try to remember to go into tools and put the stitch width safety on so that I don't forget & try to zig zag with it 
I do use the 1/4 "option in the settings when I am attaching my binding with a walking foot.... but I usually move the default over to 2.3 .... (but then when I trim my batting I leave a tad to fill out the binding) .... It took a little practice to get it just where I like it.
Welcome to the forum.... is this machine new to you?
I do use the 1/4 "option in the settings when I am attaching my binding with a walking foot.... but I usually move the default over to 2.3 .... (but then when I trim my batting I leave a tad to fill out the binding) .... It took a little practice to get it just where I like it.
Welcome to the forum.... is this machine new to you?
Thread
Thread Starter
Forum
Replies
Last Post
johnette
Main
41
11-30-2010 11:00 PM
