do you just go with it?
#1
Super Member
Thread Starter
Join Date: Mar 2013
Location: Southern Indiana
Posts: 3,111
do you just go with it?
I have a panel that I am going to put together a quick little quilt on. The problem is that the printing doesn't seem to printed straight on the fabric. See the squirrel on the picture. the block is cut square, but she is crooked
Is there a way to straighten it or should I just go with it?[ATTACH=CONFIG]568913[/ATTACH]
Is there a way to straighten it or should I just go with it?[ATTACH=CONFIG]568913[/ATTACH]
#2
Power Poster
Join Date: Feb 2009
Location: Northern Michigan
Posts: 12,861
Panels are often not printed straight. I would try pulling on opposite corners and steam to try to square it, if that doesn't work I would cut it square. You could cut each square inside those ( frames) then add your own new washing so they are all straight and the same size. Very cute!
#3
Power Poster
Join Date: May 2009
Location: NY
Posts: 10,590
As ckcowl stated.... As a result when I work with panels, especially ones that are meant to be cut apart I won't cut them on the straight of grain but rather with the print, which while not on grain is usually a true square or rectangle (ie the corners are a true 90 degrees). Works for me because I am usually going to sash them in some way so I don't care if the edges are cut off grain. I just handle them carefully to minimize fraying.
#4
Yes, in this case square up inside the coloured frame. I have often 'blocked' a panel when it is bowed or skewed. I take the straightest edge and tape it to my table or floor. Then 'persuade' the rest of the panel to become square with the first edge, usually by dampening, gently stretching (or bunching) the edges, taping down and then wetting thoroughly and letting it dry. I will use it immediately so that it retains the 'corrected' shape.
#10
Super Member
Join Date: May 2011
Posts: 4,688
Great ideas. I encountered a large panel (ordered online) that was so badly skewed that I had to mark the center of the interior scene, then square it up like a quilt before I sashed it. I had to add corner triangles to cover up part of the border that had to be included when I squared it. I had meant to make it for a DGS, but was so frustrated I gave it away.
Thread
Thread Starter
Forum
Replies
Last Post
ruby2shoes
Main
25
09-20-2015 04:01 PM
kellen46
General Chit-Chat (non-quilting talk)
22
04-24-2013 07:12 AM
ILoveToQuilt
Main
62
04-09-2012 10:43 AM
Fab-ra-holic
General Chit-Chat (non-quilting talk)
42
06-22-2011 09:23 AM