Rhonda K

I need to piece the backing for a recent quilt and stitch 1/2 inch seams. I will starch and press the seam after piecing.

Have you/would you top stitch down the seam line? Press the seam open or to one side? Seam line horizontal or vertical? The quilt is 50x 50 so the backing will be 60x60. I purchased 4 yards of fabric so should have plenty.

Of course, I can check with the long-armer next week. It's just been a while since I finished a quilt and forget the details of piecing the back.

Thanks for your help and/or suggestions.

dunster

Longarmers prefer the seams to be horizontal.

I would press to the side and would not top stitch.

Jane Quilter

i would press to the side and not topstitch.

Barb in Louisiana

I do my own quilts and do use a 1/2" seam when seaming the backing. I iron the seam open. I do the seam on the horizontal. I didn't think it would matter, and I did a seam on the vertical. It made sense to do it that way because I needed about 80" width for the backing and that way I only had to sew 1 seam. It was a big mistake. Every time I rolled the quilt on the Longarm frame, the center got higher and looser on each side of it. I fought that quilt to get it to stitch evenly. I now, either do a diagonal seam now or a horizontal one when I piece the backing.

PaperPrincess

if possible the seam should be horizontal, but with a quilt that small, the long armer can load it on the frame turned 90 degrees so in this case, it probably doesn't matter. I use a half inch seam and press open. Remember to remove the selvedges from the seamed edge. I usually do about a 1" seam, then cut both selvedges off.

QuiltE

The Longarmers that I have dealt with ask for it to be horizontal with 1/2" seam, pressed open.
(agree with PaperPrincess, that shouldn't be an issue, as they can load it with the 90° turn.)

As you can see there are different thoughts as to what to do with a pieced backing.

.... you really would be best to speak directly with your LA'er and do it the way s/he wants done!

Macybaby

I do a 1/2 seam and press it to one side.

Rotating the quilt is only a problem if you want an all over pattern that is directional. I have several that are up and down, and it would look really silly to put them on a quilt so they went left/right. I've done several edge to edge from top to bottom instead of side to side, and they look fine.

Rhonda K

Thank you for your thoughts and help. I am using the uncorked line of fabric and just realized it is directional. It will look best with the lines running up and down.

I will check with the longarmer to make sure she can rotate the quilt. I always mark the backing with TOP and BOTTOM arrows so it is oriented correctly.

NoraB

Since everyone seems to fold quilts right down the middle, I figure I'd reinforce it on that backing seam. I sew 1/2 inch seam allowance, press it open and then stitch on each side of the seam about 1/4 inch from the seam. I match the fabric, so it's not too easy to see. Since I longarm it myself, I prefer the bulk on that seam to be open. They are charity or baby quilts, so I'm hoping they will be well used. So, reinforcing that seam just seems right to me. And, yes...horizontal seam........it's too hard for me to roll those guys and prevent puckers, etc. when the seam is vertical.

mac

Several of you have commented on making a '1/2" seam' for the backing. Is there a special reason to do this? I usually just do a 1/4" seam and never thought about making it wider? Does this make the back seam stronger or last longer?? Just wondering...