On Ringo Lake -- Bonnie Hunter Mystery Quilt 2017-18
#961
Super Member
Join Date: Aug 2010
Location: Camarillo, CA
Posts: 4,607
Hi everyone! I am done with Clue 1 and Clue 2. I am having a problem with Clue 3. When I cut a 2 x 5" piece, and add a side piece using my Corner Clipper Ruler at 2", I am coming out with a 2 x 4 1/2" piece, which makes sense since I am sewing 2 of the triangles onto the 2 x 5". According to Bonnie's instructions, each unit should be 2 x 5" before being sewn into the quilt. Where am I going wrong here??? Help!
#963
Senior Member
Join Date: Jun 2010
Location: South Range, WI
Posts: 458
Hi everyone! I am done with Clue 1 and Clue 2. I am having a problem with Clue 3. When I cut a 2 x 5" piece, and add a side piece using my Corner Clipper Ruler at 2", I am coming out with a 2 x 4 1/2" piece, which makes sense since I am sewing 2 of the triangles onto the 2 x 5". According to Bonnie's instructions, each unit should be 2 x 5" before being sewn into the quilt. Where am I going wrong here??? Help!
#964
But if you are putting the square on the end and stitching diagonally then trimming excess you should end up w/ the same size as the original foundation rectangle (5 inches) since the top square when folded into position should meet the edge of the foundation. I have never had much success w/ that method personally, but mostly w/ distorted ends not w/ loosing the 1/2 inch length.
#965
I've not liked these units in previous quilts. I paper pieced them before but that is slow going for me. What is working for me. Cut 5 inch rectangle, add trimmed corner on full rectangle, sew, then trim rectangle. I have cut the neutral triangles with accuquilt die and they are starched. would be the same if cut with a ruler. I am also pressing seams open as I get distortion when I try to make some of the seams conform to the pressing instructions from Bonnie.
[ATTACH=CONFIG]585022[/ATTACH]
[ATTACH=CONFIG]585022[/ATTACH]
Last edited by Pagzz; 12-09-2017 at 01:34 PM. Reason: spelling
#967
Super Member
Join Date: Aug 2010
Location: Camarillo, CA
Posts: 4,607
I get the correct size if I cut the orange rectangle to 5 1/2". Think I will go with that.
#968
Wish I could help you Jeannie, but I don't have that corners ruler to work with.
Here are my clue 3 units. So glad to be done for another week. I made 60 lefties and 60 righties. I did the first group the way Pagzz showed, but also found that pressing the way Bonnie said to was distorting them. So the second group I trimmed the center rectangle to the proper diamond shape by following the ruler marks that Cathy showed in her tute. Worked much better that way!
[ATTACH=CONFIG]585025[/ATTACH]
Here are my clue 3 units. So glad to be done for another week. I made 60 lefties and 60 righties. I did the first group the way Pagzz showed, but also found that pressing the way Bonnie said to was distorting them. So the second group I trimmed the center rectangle to the proper diamond shape by following the ruler marks that Cathy showed in her tute. Worked much better that way!
[ATTACH=CONFIG]585025[/ATTACH]
Thread
Thread Starter
Forum
Replies
Last Post
Podunk Princess
QuiltingBoard Challenges & Contests
2033
01-11-2022 06:54 PM