GrannieAnnie

GMTA. I replied much the same before seeing your reply.

Diane C.

I go with tartan's reply. Some are very hard to quilt through, some are ok. You can by muslin pretty cheap on sale. Diane c

sweetpea

Thank you "GrannieAnnie and PaperPrincess" for pointing out my dum question. The sheet is to short and I was hopeing that if I toke the hem and top out it would work . I do know that I can use it either way. but as the sheet that I was hopping to use is a directional print It dose need to go in the right direction. again thanks for you help and I'm sorry that I don't add that to my frist post. but I just don't think I needed to be point that out. Sorry

cynicalbeauty

My long armer says she prefers nothing over 400. I usually buy my sheets for quilt backs at target. They sell the flat sheets separately and they are so soft. They are pretty inexpensive to start and sometimes you can find them on sale, also they come in several colors. I have also never had a problem with these sheets being big enough. A queen sheet fits a queen quilt. I have had problems with other sheets being too small. http://www.target.com/p/threshold-ul...erm=flat+sheet

cynicalbeauty

I don't know about others, but I always remove the seams on the sheet with my ripper before I use them, This makes it slightly bigger than the measurement on the package depending on the type of sheet you buy.

ShirlinAZ

I often use sheets as backs, and agree that the 200 or 300 thread count is best. It is true that needles can break the fabric threads in really high thread count fabrics. The idea that higher thread count is better is a Myth of urban legend proportion. Only so much thread will fit into an inch. A thread count of anything over 400 is achieved by using finer and finer threads. It's equivalent to using 100 wt thread instead of 20 wt.

Sweetpea, your sheet is 108" wide. But does it really matter? In reality your usable fabric will be 108 x 98 (est) because of the wider hem on one edge. You will have to open that up or cut it off. Unless it is a directional print that must go one way, it shouldn't make a difference which way you turn the usable fabric.

peacefulquilting

I'm just thrilled to see that no one on here was fussing about people using sheets as backing!! Maybe the "quilt police" decided to remain quiet this time!!!

CookieRN

The idea of flannel sheet for backing sounds absolutely wonderful. Do you think it would make a huge difference since I dont prewash my top material.. ( i like the wrinkly shrinkage look). will the back just kinda shrink up with the top after I wash it.. even though it wouldnt actually "shrink" - being a sheet?

justflyingin

I was waiting for it too.

My only bad experience was by using a tightly woven fabric (a duvet cover) when I was FMQ, I had problems with skipping. When I was on my blocks, all was fine, but as I was on the sashing, I had problems. The sashing was the very tightly woven, dense fabric. The tightly woven felt wonderful, but it did make things more difficult. It's not an urban myth.

crafty pat

I have hand quilted quilts my DM made 30 to 40 years ago using sheets for backing and they are all still in perfect shape through a lot of use and washing's.