jstitch

Here are the steps I use to make a hanging sleeve.


First cut a piece of fabric 8 inches x the width of the quilt inside the bindings + 1 inch.

I use muslin if I dont have any of the fabric that the backing is made of

jstitch

hem one end of the strip

jstitch

Fold the strip in half lengthwise and sew a seam down the length

jstitch

Open the sleeve and move the seam to the middle of one side and press the length of the sleeve

jstitch

Measure the width of the quilt between the bindings and hem the other end of the sleeve.

Fold the sleeve in half to find the middle.
Do the same with the quilt.

Starting at the middle of both, pin the sleeve just under the binding with the seam facing the quilt

jstitch

Beginning at one end,

if right handed start at the right end, left handed, the left end..

Start by sewing the lower edge of the end of the sleeve to the quilt using a blind hem stitch. Catch the sleeve with the needle, then pass the needle into the quilt back and batting and come up about 3/8 inch away and through the sleeve

jstitch

Continue in this fashion, sewing to the corner, then along the folded top edge, along the other end and back along the bottom folded edge, ending where you started

jstitch

Slide a rod through the sleeve and hang.

Here is my hanging rod and a quilt hanging from it

Belinda

THANK YOU so much! Great, easy to understand instuctions. I've always wondered how to do this! :thumbup: :thumbup:

mgshaw

Great tute Judy! Thanks!!!