|
Originally Posted by Mizkaki
(Post 6592557)
Tammi,
I usually buy from my supplier the 11mm wide width ZZ bobbin case. I think it is #JO1313Z. It's listed as high quality. Yes, the side loaders don't need the wide slot. Cathy |
Tammi,
The jo1313, JO1313z and JO1313ZW all will work in the side load. The JO1313 is for the side loaders (and not the front loaders), as it has the short slot. The Jo1313ZW is the same as the JO1313Z (that I order) except it has the tip of the lever bent slightly outward. Cathy
Originally Posted by ArchaicArcane
(Post 6592571)
The ones I ordered for stock were the JO1313 and the JO1313ZW, I've used one of the JO1313ZW. I'm sure I remember using it in a side loading machine and both of the JO1313 are still here. Or else I stole one from a front load and put it in a side load and replaced that one into a front load. I must have been lucky in that I didn't try to go the other way. :)
|
Holy Cow! Where were you when I was trying to puzzle that out just based on part #s? Thanks so much for that. :)
|
I was right here (rebuilding an old Necchi motor which was being a royal pain in the patooty).
Just email me (PM first for my email address). Cathy
Originally Posted by ArchaicArcane
(Post 6592591)
Holy Cow! Where were you when I was trying to puzzle that out just based on part #s? Thanks so much for that. :)
|
I ordered the cases about 16 months ago. But I will definitely PM next time I just can't figure it out, since I now have a couple of cases sitting around that I may never use because I didn't ask. ;)
Oh! And to MiniBarn... uh... sorry for the hijacked thread. :( |
That's OK, we all still learn stuff!
JP |
| All times are GMT -8. The time now is 10:45 PM. |