san-sing

My 301 will sew perfectly for a while then just loop on the bottom for an inch or two. Sometimes it sews without doing this at all, what could be the problem? I just recently got it, I oiled it, and changed the needle. Could it be the wrong size needle?

J Miller

Hmmm, Does this happen right after you raise the foot to change directions maybe? Perhaps the pin that releases the tension is sticking when you lift the presser foot? Then working loose and releasing the tension like it should.
The looping is a sign of no or insufficient top tension.

Joe

cricket_iscute

I agree with Joe. Unthread the machine (do NOT pull the thread from bottom up; instead, cut thread above tension and sacrifice that bit of thread by pulling it through the needle and out of the machine. Always do it this way or you risk pulling lint back into the machine's tension.) Take unwaxed dental floss and floss the tension, especially in between the discs. Re-thread and see if that helps.

miriam

look to see if you thread it the right direction and put the need in right - info should be in your user manual

san-sing

Thanks for the suggestions I will check the tension disk, that is something I haven't done. I will try the dental floss suggestion also. It is a little louder than my other 301, I might need to oil some more.